Model HEAT PRO How-to Use
The Model HEAT PRO package includes one hot air tool.
Model HEAT PRO Specifications
Wattage | up to 1200 Watts |
Temperature | Dual Temperature |
| Low 500°F / High 1000°F |
Volts | 120 Volts |
AMPS | 10 AMPS |
Heat Output | 68 BTU |
Weight | 1.4 lbs. |
Cord Length | 6 feet |
Settings | Low, Off, High |
Operation of the Model HEAT PRO
The following instructions are a general guideline for using the Model HEAT PRO hot air tool. Every project is different so use these instructions as a starting point to determine the best heat setting and distance for your project.
Before plugging the Model HEAT PRO into an electri- cal outlet make sure the switch is in the Off position.
1.Plug into a standard 3-hole outlet.
2.To start, slide the switch to either the Low or High position. The
Note: Smoke may appear during the initial start up due to the burning of manufacturing oils. The smoke should disappear in less than a minute.
Caution: If the blower motor in the hot air tool does not turn on when the switch is set to either Low or High, turn the switch to Off immediately. The heating element will burn
out if it is not cooled by the blower.
3.For instructions on how to strip paint go to section HOT AIR TOOL OPERATIONAL GUIDE- LINES, How to Strip Paint.
4.To turn off when finished, slide the switch to the Off position and unplug. Set the Model HEAT PRO upright on a stable, level surface. This will speed up the cooling process because the air will flow naturally upward over the heat- ing element. Allow the Model HEAT PRO to cool completely. Make sure the Model HEAT PRO is completely cooled before storing.
Model HEAT PRO
Uses and Corresponding Heat Settings
Removal | Setting |
Soften paint and varnish | High |
Urethane from furniture and woodwork | Low |
Stickers and bumper stickers | Low |
Vinyl flooring | High |
Linoleum | High |
Laminate | High |
Caulk | High |
Window putty | High |
Drying |
|
Metal surfaces prior to painting | High |
Ignition system | Low |
Heating |
|
Shrink tube/wrap | Low |
Window shrink coverings | Low |
Frozen locks and water pipes | Low |
Bearings and gears for assembly | High |
Loosening rusted bolts | High |
Other |
|
Soldering water pipes | High |
Welding plastic | High |
Bending plastic/poly carbonate | Low |
Waxing skis | Low |
| MODEL HEAT PRO | ENGLISH 7 |