Model Heat PRO Plus How-to Use

The Model HEAT PRO PLUS kit includes one hot air tool, one concentrator nozzle and one scraper nozzle.

Model HEAT PRO PLUS Specifications

Wattage	up to 1300 Watts
Temperature	Dual Temperatures
	Low 600°F / High 1100°F
Volts	120 Volts
AMPS	11 AMPS
Output	74 BTU
Weight	1.8 lbs.
Cord Length	6 feet
Settings	High, Low, Cool, Off

Operation of the Model HEAT PRO PLUS

The following instructions are a general guideline for using the Model HEAT PRO PLUS hot air tool. Every project is different so use these instructions as a starting point to determine the best heat set- ting and distance for your project.

Before plugging the Model HEAT PRO PLUS into an electrical outlet make sure the switch is in the Off position.

1.Plug into a standard 3-hole outlet.

2.To start, slide the switch to either the Low or High position. The motor-driven fan noise will indicate the unit is running. The heating coil will light up and slowly turn red.

Note: Smoke may appear during the initial start up due to the burning of manufacturing oils. The smoke should disappear in less than a minute.

Caution: If the blower motor in the hot air tool does not turn on when the switch is set to either Low or High, turn the switch to Off immediately. The heating element will burn

out if it is not cooled by the blower.

3.For instructions on how to strip paint go to section HOT AIR TOOL OPERATIONAL GUIDE- LINES, How to Strip Paint.

4.To turn off when finished, slide the switch to the Cool position, point the nozzle up and let run until cool. Then slide the switch to the Off position and unplug. Set the Model HEAT PRO PLUS upright on a stable, level surface. This will speed up the cooling process because the

Concentrator Scraper

Nozzle

air will flow naturally upward over the heating element. Allow the Model HEAT PRO PLUS to cool completely. Make sure the Model HEAT PRO PLUS is completely cooled before storing.

How To Attach Accessories to the Model HEAT PRO PLUS

1.Set the Model HEAT PRO PLUS upright on a level surface, make sure tip is cool.

2.Set the accessory nozzle on the top of the open nozzle and push firmly into place.

3.To remove, set hot air tool with nozzle facing up; wait for it to cool.

4.Pull the accessory nozzle off the top using a twisting motion and straight pull.

5.Only use accessories designed for this hot air tool.

MODEL HEAT PRO PLUS

ENGLISH 8