Operation Instructions
1.With the proper tool attached to the Air Hammer, attach your air supply to the Air Inlet (7) at the base on the Housing (1). Turn on the air supply. Carefully place the tool against the surface of the project you are working with. Make sure the project is in a vise or attached to something that holds it securely so it cannot be moved out of position.
2.Set the Air Regulator (11) located at the base of the Housing (1). Air pressure should not exceed 90 PSI. Test the action of the Air Hammer and adjust the Air Regulator (11) as necessary.
3.Use a light touch on the Trigger (8). Never force the Air Hammer against the surface you are working with. Easy, light pressure works best.
WARNING: If the Air Hammer is being used as a Scaler, use a
INSPECTION, MAINTENANCE, AND CLEANING
1.
WARNING! Make sure air compressor is unplugged and that the Air Hammer is disconnected from its Air Supply before performing any inspection, maintenance, or cleaning procedures.
2.BEFORE EACH USE, inspect the general condition of this tool. Check for loose screws, misalignment or binding of moving parts, cracked or broken parts, damaged air hoses, and any other condition that may affect its safe operation. If abnormal noise or vibration occurs, have the problem corrected before further use. Do not use damaged equipment.
Maintenance Chart
Maintenance Type | Before | After | Weekly | Monthly | Every 6 | Yearly |
Use | Use | Months | ||||
Inspect the Air Hammer for | X | X |
|
|
|
|
damage |
|
|
|
| ||
(see #2, above) |
|
|
|
|
|
|
|
|
|
|
|
|
|
Wipe off with clean, moist |
| X |
| X |
|
|
cloth |
|
|
|
| ||
|
|
|
|
|
| |
|
|
|
|
|
|
|
Troubleshooting
Problem |
| Possible Causes |
| Probable Solutions |
Air Hammer will not | 1. | Air supply not connected. | 1. | Check air connection. |
start | 2. | Air Regulator (11) not turned up. | 2. | Turn up Air Regulator (11). |
| ||||
|
|
|
|
|
SKU 95801 | For technical questions, please call | Page |