RIDGID R848 manual Replacing Blades, Blade Blade Clamp Wrench Screws Tapered Edge

Page 19

MAINTENANCE

REPLACING BLADES

See Figures 17 - 18.

Always replace blades in pairs. Do not attempt to sharpen blades. If the blades become dull, replace them.

When replacing the blades, use recommended replacement blade only, RIDGID part number 671480001.

WARNING:

Blades are sharp. Use extreme caution when replacing the blades. Failure to heed this warning can result in serious personal injury.

nRemove the battery.

nSecure the planer in an upside-down position.

nLoosen the three screws securing the blade and blade clamp on the blade holder using the blade wrench pro- vided.

NOTE: Before removing the old blades, take notice of the direction of cut as well as how the tapered edge of the old blades are oriented. The tapered edge of the new blades must be in the same orientation as the original blades, with the tapered edge on the same side as the screw heads and the flat edge facing the cylinder.

nRemove the blade and blade clamp.

nRemove the old blade from the blade holder.

nClean any sawdust or wood chips from around the blade area.

nPlace the new blade in position on the blade holder, with the three screws aligned with the screw holes.

nReplace the blade clamp.

nReplace and retighten the three blade-securing screws using the blade wrench.

nRepeat the above procedure to change the other blade.

BLADE

BLADE CLAMP

BLADE

WRENCH SCREWS

Fig. 17

BLADE

TAPERED

EDGE OF

BLADE

BLADE

CLAMP

SCREWS

BLADE

Fig. 18

 

 

 

 

 

19

Image 19
Contents OPERATOR’S Manual Introduction Table of ContentsWork Area General Safety RulesElectrical Safety Personal SafetyService Specific Safety RulesSafety Rules for Charger Symbol Name DESIGNATION/EXPLANATION SymbolsSymbol Signal Meaning Product Specifications FeaturesEdge GUIDE/RABBET Guide Switch TriggerDepth Adjustment Knob Know Your Hand PlanerPacking List AssemblyINSTALLING/REMOVING the Dust BAG UnpackingOperation Charging Indicator Full Power IndicatorLED Function of Charger To Remove Battery Pack To Install Battery PackBattery Pack Latch STARTING/STOPPING the Planer Workpiece Kickstand Depth Adjustment KnobPlaning Depth Front Handle Operating the PlanerDust BAG Clamp Workpiece Planing Edges and Making Rabbet Cuts ChamferingAttaching the Edge Guide for Planing Edges Workpiece Edge Guide Planing EdgesAttaching the Edge Guide for Making Rabbet Cuts Making Rabbet CutsGeneral Maintenance MaintenanceCleaning the Exhaust Port and EMPTY- ING the Dust BAG Blade Blade Clamp Wrench Screws Tapered Edge Replacing BladesPulley Pulley Belt Cover Screws Battery Pack Removal Preparation for RecyclingReplacing the Belt BatteriesHOW to Obtain Service What is not Covered WarrantyDAY Satisfaction Guarantee Policy What is Covered Under the 3 Year Limited Service WarrantyCustomer Service Information