RIDGID R848 Planing Edges, Attaching the Edge Guide for Making Rabbet Cuts, Workpiece Edge Guide

Page 17

OPERATION

PLANING EDGES

See Figure 14.

Follow the directions in the “Planing” section earlier in this manual. Hold the edge guide firmly against the edge of the work surface.

ATTACHING THE EDGE GUIDE FOR MAKING RABBET CUTS

nLock the switch by placing the lock-off button in the center position.

nAttach the bracket to the left side of the planer using the knob bolt.

nAttach the edge guide loosely to the bracket using the knob nut and the carriage head bolt.

nAdjust the edge guide to the desired width for the rabbet cut.

nTighten the retaining knob securely.

MAKING RABBET CUTS

See Figure 15.

Follow the directions in the “Planing” section earlier in this manual. Hold the edge guide firmly against the edge of the work surface.

The depth of the rabbet is determined by the depth of the cut and the number of passes made along the work surface. The maximum depth of the rabbet cut is 1/2 in. Cuts should be made in 1/16 in. passes, or less, to reach the desired depth. The width of the rabbet cut may be adjusted by moving the edge guide.

WORKPIECE

EDGE GUIDE

Fig. 14

WORKPIECE

EDGE GUIDE

Fig. 15

17

Image 17
Contents OPERATOR’S Manual Introduction Table of ContentsElectrical Safety General Safety RulesPersonal Safety Work AreaService Specific Safety RulesSafety Rules for Charger Symbol Name DESIGNATION/EXPLANATION SymbolsSymbol Signal Meaning Product Specifications FeaturesDepth Adjustment Knob Switch TriggerKnow Your Hand Planer Edge GUIDE/RABBET GuideINSTALLING/REMOVING the Dust BAG AssemblyUnpacking Packing ListOperation LED Function of Charger Power IndicatorCharging Indicator Full Battery Pack Latch To Install Battery PackTo Remove Battery Pack Planing Depth Workpiece Kickstand Depth Adjustment KnobSTARTING/STOPPING the Planer Dust BAG Clamp Workpiece Operating the PlanerFront Handle Attaching the Edge Guide for Planing Edges ChamferingPlaning Edges and Making Rabbet Cuts Attaching the Edge Guide for Making Rabbet Cuts Planing EdgesMaking Rabbet Cuts Workpiece Edge GuideCleaning the Exhaust Port and EMPTY- ING the Dust BAG MaintenanceGeneral Maintenance Blade Blade Clamp Wrench Screws Tapered Edge Replacing BladesReplacing the Belt Battery Pack Removal Preparation for RecyclingBatteries Pulley Pulley Belt Cover ScrewsDAY Satisfaction Guarantee Policy WarrantyWhat is Covered Under the 3 Year Limited Service Warranty HOW to Obtain Service What is not CoveredCustomer Service Information