Multiquip SFG10E manual Assembly INSTRUCTIONS/OPERATIONS

ASSEMBLY INSTRUCTIONS/OPERATIONS

REMOVING A MULTI-ACCESSORY ATTACHMENT (not including multi-segmented,dry diamond discs) FROMTHE ROTATING DISC

Tools Required:

1 Small Hammer

1 Drift Punch or Small Pry Bar

4)Return the SURFACE GRINDER to its normal operating position.

5)If the machine is to be used immediately, reconnect the extension cord or SURFACE GRINDER from the power source. Determine that the ON/OFF switch located on the operator handle is in the OFF position.

DANGER

WHEN REMOVING A MULTI-ACCESSORY ATTACH- MENT FROM THE SURFACE GRINDER, ALWAYS WEAR APPROPRIATE SAFETY EYEWEAR AND AP- PARELTO MINIMIZETHE POTENTIAL FROM FLYING DEBRIS. FLYING DEBRIS CAN RESULT IN PROP- ERTY DAMAGE AND/OR PERSONAL INJURY.

1)Disconnect the extension cord or SURFACE GRINDER from the power source.

2)Tilt the SURFACE GRINDER back until the operator handle comes in contact with the surface. Appropriate wheel chocks are recommended.

3)The multi-accessory attachment can be removed by both the use of a drift punch or small, pry bar. If utilizing the drift punch, strike the narrow end of the mounting wedge with controlled, direct blows until the attachment is released from the aluminum disc. If utilizing the pry bar, position the bar between the aluminum disc and the attachment. Use controlled, direct blows to the bar in order to force the attachment loose from the aluminum disc. FIGURE 28.

FIGURE 28

CAUTION

Do not utilize excessive force when removing a multi- accessory attachment with the pry bar. Excessive force can result in damage to the aluminum disc. Proper removal techniques by both methods will result in minimal damage to the aluminum disc.

DANGER

UNEXPECTED MACHINE START UP CAN RESULT IN PROPERTY DAMAGE AND/OR PERSONAL INJURY.

TRANSPORTINGTHE SURFACE GRINDER

The SURFACE GRINDER has an operational weight that prohibits one person from loading and/or unloading it alone by conventional, physical efforts.

DANGER

DO NOT ATTEMPTTO LIFTTHE SURFACE GRINDER UP INTO A TRANSPORTATION VEHICLE WITH THE USE OF ONE PERSON ALONE. DO NOT ATTEMPT TO LOWERTHE SURFACE GRINDER FROM ATRANS- PORTATION VEHICLE WITH THE USE OF ONE PERSON ALONE. LIFT AND/OR LOWER THE SUR- FACE GRINDER ONLY BY THE USE OF A POWER TAILGATE UNIT, A SUITABLE HOIST UNIT OF PROPER CAPACITY AND/OR CONFIGURATION OR BYTHE USE OF A PROPER QUANTITY OF PERSON- NEL IN PROPER PHYSICAL CONDITION.

1)A lifting bail device can be used to facilitate lifting by a mechanical device incorporating a chain and suitable attachment device. The location of the lifting bail may not always locate the exact position of the center of gravity for the SURFACE GRINDER. Lifting handles are also provided on both sides of the transmission case. These handles can be utilized by personnel whenever lifting/lowering the SURFACE GRINDER or as attachment points for a chain sling whenever a suitable hoisting device is utilized. FIGURE 29.

SFG10E ELECTRIC SURFACE GRINDER — OPERATION AND PARTS MANUAL — REV. #2 (05/28/09) — PAGE 22