Craftsman 149.236321 owner manual Checking Cutter Blades, For Extra Stability Optional

Page 7

A= 11/16Thickx2"Widex 10"Long The11/16thicknesscanbeobtainedbyplaningtheboard onthejointer-planer.

B= 112"to3t4"Thickx3-112"Wide x 10" Long

This piece may also be made out of plywood.

,.C= 3/4" Thick x 2.112" Wide x 19-1/2" Long

'The 2-112" width may be increased if desired.

C / _- B

t .............

r i

OPTIONAL -- For Extra Stability

D= 11116" Thick x 2" Wide x 2" Long, 2 Pieces

E= 112" to 314" Thick x 3-1/2" Wide x 2" + Long, 2 Pcs.

NOTE: Cut both D pieces from the same stock or thickness as

board A and cut both E pieces from the same stock or thickness as board B.

r--E OPTIONAL

/

," FOR EXTRA STABILITY

4- -- - <_--

D OPTIONAL

it '

A

J-

B 3/4

-

CHECKING CUTTER BLADES

AND CORD IS UNPLUGGED BEFORE PROCEEDING WITH CHECK-

_ CAUTION: MAKE SURE THE SWITCH IS IN THE OFF POST ON ING CUTTER BLADES.

The blades in your Jointer*Planer have been adjusted at the factory to assure proper operation. Shipping and handling, however, may cause

misalignment. For accurate cutting, the blades must be .O03-in. higher than the outfeed table (thickness of a piece of paper) when positioned at the highest point.

1.Block the cutter guard open with a scrap piece of wood about 5-1/2" long between the fence and cutter guard.

Locate the slot in the cutter head shaft through the small hole in the backside of the machine directly above the vacuum port. Rotate the

cutter head with a screwdriver until one of the blades is at its highest position.

pJaee a straight edge over the outfeed table and the blade. The straight edge must touch evenly on the outfeed table at both ends of the blade, Rotate the cutterhead slowly, and making sure the blade lightly touches the straight edge. If the straight edge rises or blades

do not touch, follow the "REPLACING CUTTER BLADES" procedure

in the "MAINTENANCE" section.

BLADE

WOOD

CUTTERBLOCK

HEAD

CLAMP

CUTTER _RD

CHIP DISCHARGE/VACUUM

BACK 81DE OF

MACHINE

Image 7
Contents Serial Or Code Number ModelnoGeneral Safety Rules for Power Tools Table of Contents Tools Required Unpacking and Checking ContentsChip Deflector Safety Rules for JOINTER--PLANERCutter Guard Assembly Depth of CUT Hand KnobFence Fence ExtensionCountersunk Screws For Extra Stability Optional Checking Cutter BladesCord is Unplugged Before Proceeding with Check JOINTER--PLANER InstallingControls and Adjustments Fence Cutterguard Guard Stop ON-OFF SwitchCutter Guard ON.OFF SwitchGuard Stop Feeding the Work Piece Setting the Guard StopTion and the Cord Unplugged Before Setting the Guard Stop Basic JOINTER--PLANER OperationSlip While FEEDING, Clean Rubber Surface Immedi Using Hold DOWN/PUSH BlocksBeveling and Chamfering Cutter Guard Return Spring MaintenanceUsing a WET-- DRY VAC Timing Belt ReplacementGeneral Maintenance Blade Replacement and AdjustmentChip DI 8CHARGE./VACUUM Craftsman 5-1/8 Inch JOINTER-PLANER Model No Parts List Modelno Trouble Shooting ChartJOINTER--PLANER