Safety Rules for JOINTER--PLANER

Safety is a combination of operator common sense and alertness at all times when the Jointer--Pianer is being used. Study these rules and general safety rules before operating and retain them for future use.

1.WEAR EYE PROTECTION.

2.NEVER MAKE JOINTING OR PLANING CUT DEEPER THAN 1/8 INCH -- PER PASS.

3.FEED WORKPIECE AGAINST ROTATION OF CUTTER.

4.KEEP FINGERS AWAY FROM REVOLVING CUTTER -- use fixtures when necessary.

5.NEVER PERFORM JOINTING OR PLANING OPERATION WITH CUTTER HEAD GUARD REMOVED.

6.NEVER FORCE CUTTING ACTION. Stalling or partial stalling of motor can cause major damage. Allow motor to reach full speed before cutting.

7.NEVER - Attempt to perform an abnormal or little used operation without study and the use of adequate hold down /push blocks, jigs, fixtures, stops, etc.

8.NEVER- Attempt to cut small pieces.

9.ALWAYS - Use hold downlpush blocks for jointing material narrower than 3 inches, or planing material thinner than 3 inches.

10.ALWAYS - Keep cutter sharp.

11.N EVER- Use in an explosive atmosphere. Normal sparking of motor may ignite fumes.

12.OUTDOOR EXTENSION CORD USE - When tool is used outdoors, use only extension cords suitable for use outdoors. Outdoor approved cords are marked with the suffix W-A, for example - SJTW-A or SJOW-A.

13.ALWAYS use identical replacement parts when servicing.

14.This tool is intended for RESIDENTIAL USE ONLY.

WARNING: DO NOT ALLOW FAMILIARITY (GAINED FROM

FREQUENT USE OF YOUR JOINTER--PLANER) TO BECOME

COMMONPLACE. ALWAYS REMEMBER THAT A CARELESS FRACTION OF A SECOND IS SUFFICIENT TO INFLICT SEVERE INJURY.

WARNING: DO NOT AT ANY TIME LET BRAKE FLUIDS, GASOLINE, PENETRATING OILS, ETC.

,_ COME IN CONTACT WITH PLASTIC PARTS. THEY CONTAIN CHEMICALS AND/OR DESTROY PLASTICS.

THAT CAN DAMAGE

ASSEMBLY

DEPTH OF CUT HAND KNOB

1.Find one 3/8 tockwasher and the depth of cut hand knob from the parts bag.

2.Turn the nut on the height adjustment screw until five full threads extend beyond the nut.

3.Place Iockwasher on height adjustment screw and thread hand knob

onto screw,

4.Back nut up against hub of hand knob. Tighten with 14mm or 9/16 wrench while holding hand knob.

CHIP DEFLECTOR

1.Loosen the screw in the center of vacuum port of chip discharge,

2.Install slot of chip deflector between the chip discharge and the flat washer and retighten.

,_CAUTION:	THE CHIP DEFLECTOR			MUST	BE IN	PLACE FOR	SAFE
OPERATION.		FAILURE	TO INSTALL	THE	CHIP	DEFLECTOR	MAY
RESULT	IN	PERSONAL	INJURY.

CUTTER GUARD ASSEMBLY

1.Place the slot on the guard stop assembly over the tab on the front cover as shown and align the shoulder bolt with the threaded hole,

2.Rotate the cutter guard counterclockwise until the tab Is under the cutter guard and tighten the shoulder bolt, Be sure the cutter guard rotates freely after tightening the shoulder bolt.

OPERATION. FAILURE TO INSTALL THE CUTTER GUARD CAN

_1 AUTION: THE CUTTER GUARD MUST BE IN PLACE FOR SAFE kRESULT IN SERIOUS PERSONAL INJURY.

3/8 HEX NUT

DEPTH OF CUT

HAND KNOB

LOOSEN AND

RETIGHTEN_.

TH IS__..

DEFLECTOR

SHOULDER BOLT

SLOTS _ "_CCW

ARD