To Install Rabbet Fence
1.Loosen the rabbet fence adjustment knob (G).
2.Slide the crossbar on the rabbet fence (F) into the hole near the front of the planer as shown in Figure 5.
3.Securely tighten rabbet fence adjustment knob (G) as shown in Figure 6.
4.The rabbet fence should be below the planer when installed correctly as shown in Figure 5.
FIG. 5 | FIG. 6 |
G
F
To Make a Rabbet Cut
1.To adjust the width of cut loosen rabbet fence knob (G), move fence to the desired position then securely tighten rabbet fence knob.
2.Make several cuts until the desired depth is reached.
NOTE: It will be necessary to make quite a few cuts for most rabbet applications.
To Change Blades (Fig. 7, 8, 9, 10)
WARNING: To reduce the risk of serious personal injury, turn tool off and disconnect tool from power source before making any adjustments or removing/ installing attachments or accessories.
NOTE: The
Reversible Carbide Blades
1.To Remove Blade from Planer
a.Loosen and remove the three hex head screws (J) with the 5 mm hex wrench provided. Remove the drum cover (K) from the drum (Q).
b.Remove the blade carrier/guide bar assembly. Carefully remove the carbide blade (I).
FIG. 7 | M |
| Q | FIG. 8 | I |
|
|
|
| K |
|
| Q | L |
| J | |
|
|
|
|
| ||||
L |
|
|
|
|
|
|
| |
|
|
|
|
| P |
|
| |
P |
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
| |
J |
|
|
|
|
|
|
|
|
| I |
|
|
| M |
|
| K |
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
| |
FIG. 9 | P | M |
| FIG. 10 | P | M | R | O |
| L | I |
|
| ||||
|
|
|
|
|
|
| ||
|
| N |
|
|
| N |
|
|
|
|
|
|
|
|
|
| |
|
|
|
| O |
|
|
|
|
2.To Adjust Blade Using Gauge Plate (provided with tool)
a.Cautiously place the carbide blade on the gauge plate (N) with the grooved side of the carbide blade facing up. Either edge of the reversible carbide blade can be set flush against the gauge plate inside wall (O).
b.Place the blade carrier/guide bar assembly on the blade so that the rib on the blade carrier (L) fits into the groove on the carbide blade (I). The heel of the blade carrier (M) will overlap the end of the gauge plate (N).
c.Loosen the two hex screws (P) with the 2.5 mm hex wrench provided.
6