Grizzly G1021x owner manual Extension Tables, Handwheel, Components and Hardware Needed Qty

Extension Tables

Components and Hardware Needed:	Qty
Extension Tables	2
Hex Bolts M8-1.5 x 25	6
Set Screws M8-1.25 x 20	6
To attach the extension tables:

1.Attach the extension tables to the planer table with the hex bolts, as shown in Figure 6, but do not fully tighten the bolts at this time.

2.Insert the set screws into the locations shown in Figure 6.

Hex Bolts and

Set Screws

Figure 6. Extension table attached to bed.

3.Using the straightedge as a guide, turn the set screws individually until the extension tables are level with the table, and then fully

tighten the hex bolts.

Handwheel
Components and Hardware Needed:	Qty
Handwheel	1
Handwheel Handle	1
Key 4 x 4 x 10	1
Hi-Lo Scale	1
Hex Nut M10-1.25	1
Flat Washer 10mm	1
To install the handwheel:

1.Fit the handwheel key into the keyway on the handwheel shaft.

2.Slide the handwheel onto the handwheel shaft, ensuring the key fits into the keyway inside the handwheel bore.

3.Slide the Hi-Lo scale onto the handwheel shaft, and secure the handwheel using the included 10mm flat washer and M10-1.25 hex nut.

4.Thread the handwheel handle into the hole in the handwheel, and tighten the jam nut.

Figure 7. Handwheel installed on shaft (handwheel handle removed for clarity).

-14- G1021X 15" Extreme Series Planer