Knife Setting Gauge
Assemble the knife setting gauge using the knife setting gauge rod, feet and 9mm
Figure 14. Knife setting gauge assembly.
Dust Collection
DO NOT operate the Model G0633/G0634 without an adequate dust collection system. This machine creates substantial amounts of wood dust while operating. Failure to use a dust collection system can result in short and
Recommended CFM at Each Dust Port: 400
Do not confuse this CFM recommendation with the rating of the dust collector. To determine the CFM at the dust port, you must consider these variables: (1) CFM rating of the dust col- lector, (2) hose type and length between the dust collector and the machine, (3) number of branches or wyes, and (4) amount of other open lines throughout the system. Explaining how to calculate these variables is beyond the scope of this manual. Consult an expert or pur- chase a good dust collection
G0633/G0634 Jointer/Planer Combo Machine
To connect a dust collection hose:
1.Fit the 4" dust hose over the jointer dust port, (see Figure 15), or over the planer dust port (see Figure 16), depending upon which operation mode is setup, and secure in place with a hose clamp.
Figure 15. Dust hose attached to jointer dust
port.
Figure 16. Dust hose attached to planer dust
port.
2.Tug the hose to make sure it does not come off.
Note: A tight fit is necessary for proper per- formance.