Grizzly G0505 instruction manual Mounting to Bench Handle Assembly, To mount the planer

Page 13

Mounting to Bench

 

Handle Assembly

 

 

 

 

 

 

The planer can be directly mounted to a bench or table top, or to a Shop Fox® Deluxe Tool Table for increased stability during planing.

To mount the planer:

1.Determine the correct length of hex bolts needed to mount the planer to your work- bench. This will be the height of the planer mounting holes, plus the thickness of your workbench, plus an extra 12" for washers and the hex nut.

2.From the hardware store, get (4) 18" hex bolts that meet the length requirements for your setup. Also get (8) 12" flat washers, (4) 12" lock washers, and (4) 12" hex nuts.

3.Mount the planer to your workbench with your hardware in the order shown in Figure 3.

Planer Mounting

Hole

Workbench

Figure 3. Mounting planer to bench.

To attach the handle assembly:

1.Align the flat portion inside the handle bore with the flat portion on the shaft.

2.Insert the handle assembly on the shaft that protrudes out of the top of the planer (see Figure 4).

3.Thread the M5-.8 x 20mm cap screw through the handle and into the shaft to secure the handle in place. DO NOT over-tighten.

Figure 4. Attaching handle.

 

 

 

-11-

 

 

 

 

 

 

G0505 1212" Lean & Mean Portable Planer

Image 13
Contents 121⁄2 Lean & Mean Portable Planer Page Table Of Contents Safety Instructions For Power Tools Safety25ft 50ft 100ft Length AMP RatingAdditional Safety Instructions For Portable Planer Introduction 110V Operation Circuit RequirementsGrounding Extension CordsIdentification Controls & FeaturesUnpacking SET UPPiece Inventory Hardware Recognition Chart Site Considerations Clean UpTo attach the handle assembly Mounting to Bench Handle AssemblyTo mount the planer To secure the chip deflector Chip Deflector Test RunReset Button ON/OFF SwitchOperations Planing Tips Depth Of CutWood Types Pitch & Glue Build-up Wavy SurfaceChip Marks or Indentations General MaintenanceKnife Sharpening To replace the belt MotorBeltFeed Rollers To clean the feed rollersLubrication Knife Setting Service AdjustmentsIf adjustment is necessary, proceed as fol- lows Extension WingsTo install and adjust the knives Reference Info Machine Data Sheet G0505 12 1⁄ 2 Lean & Mean Portable Planer Description G0505 121⁄2 Lean & Mean Portable Planer Motor Assembly G0505 12 1⁄ 2 Lean & Mean Portable Planer Base Assembly Warranty and Returns Warranty Card BOX BELLINGHAM, WA Grizzly INDUSTRIAL, INCCall Today For a Free Full Color Catalog