Jet Tools JPM-13CS operating instructions Electrical Connections

Page 30

17.0Electrical Connections

30

Image 30
Contents Planer/Molder Part No. M-708524Warranty and Service Warranty PeriodTable of contents Safety warnings Volts Total Length of Cord in FeetAbout this manual 115 Volt operation Electrical connectionsGrounding instructions 230 Volt operationOn-Off Switch Padlock Specifications JPM-13CSGlossary Setup and assembly Adjustments PlaningFeed rate adjustment Knife adjustmentAdjusting V-Belt Tension Knife replacement Adjusting infeed roller and outfeed rollers for planingPlaning procedure Adjusting chip deflectors for planingDealing with warped wood Wood Grain Molding setup and adjustmentsInstalling molding cutters For 2 and under cuttersSetting feed rollers for molding Making & installing a bedboard Guide rail placement and attachmentMaking guide rails Molding procedure Setting table height for first passBack Relief Molding MaintenanceDisconnect machine from power source unplug Tongue and Groove MoldingTrouble Troubleshooting the JPM-13CSMechanical and electrical problems Probable Cause RemedyPerformance problems Replacement Parts Table and Base Assembly Exploded View Table and Base Assembly Parts List Index No Description Size QtyCutterhead and Roller Assembly Parts List PGE-B19C Gearbox Assembly Parts List MHA-G Stand and Motor Assembly Parts List PJA-C03 Electrical Connections Page New Sanford Road LaVergne, Tennessee Phone