Jet Tools JPM-13CS operating instructions Specifications

Page 8

7.0 Specifications

Model number

JPM-13CS

Stock Number

708524

Capacities:

 

Maximum Cutting Width

13” (330 mm)

Maximum Thickness

6-1/8” (156 mm)

Full Width Depth of Cut

1/16”

Minimum Planing Length

14” (356 mm)

Cuts per Minute

13,500

Feed Rate, Planing

20 fpm

Feed Rate, Molding

10 fpm

Cutterhead:

 

Number of Knives

3

Knife Size

13-1/16”L x 1/8”W x 5/8”H

Cutterhead Diameter

2-9/16”

Cutterhead Speed (RPM)

4500

Motor and controls:

 

Motor type

totally enclosed fan cooled, induction, capacitor start

Horsepower

1-1/2 HP

Phase

single

Voltage

115/230V (prewired 115V)

Cycle

60Hz

Listed FLA (full load amps)

15/7.5 A

RPM

3450

Start capacitor

400MFD, 125VAC

Power transfer

v-belt

On/off switch

push button

Motor speed

3450 RPM

Power plug installed

120V

Recommended circuit and fuse/breaker size1

30A (115V), or 15A (230V)

1 subject to local/national electrical codes.

 

Dust collection:

 

Dust port outside diameter

4” (100mm)

Minimum extraction volume required

350 CFM (18CMM)

Dimensions and weights:

 

Overall Dimensions

23-31/32”W x 36-1/2”D x 43-1/2”H

Net Weight (approx.)

225 lb (102 kg)

Shipping Weight (approx.)

262 lb (119 kg)

The specifications in this manual were current at time of publication, but because of our policy of continuous improvement, JET reserves the right to change specifications at any time and without prior notice, without incurring obligations.

IMPORTANT:

The use of a dust chute and adequate dust collection system is highly recommended but not required for most planing operations.

The use of a dust chute and adequate dust collection system is required for all molding operations.

For a complete line of woodworking dust collectors, contact your local JET distributor, or visit our website at www.jettools.com.

8

Image 8
Contents Planer/Molder Part No. M-708524Warranty and Service Warranty PeriodTable of contents Safety warnings Volts Total Length of Cord in FeetAbout this manual Electrical connections Grounding instructions115 Volt operation 230 Volt operationOn-Off Switch Padlock Specifications JPM-13CSGlossary Setup and assembly Adjustments PlaningAdjusting V-Belt Tension Feed rate adjustmentKnife adjustment Knife replacement Adjusting infeed roller and outfeed rollers for planingDealing with warped wood Planing procedureAdjusting chip deflectors for planing Molding setup and adjustments Installing molding cuttersWood Grain For 2 and under cuttersSetting feed rollers for molding Making guide rails Making & installing a bedboardGuide rail placement and attachment Molding procedure Setting table height for first passMaintenance Disconnect machine from power source unplugBack Relief Molding Tongue and Groove MoldingTroubleshooting the JPM-13CS Mechanical and electrical problemsTrouble Probable Cause RemedyPerformance problems Replacement Parts Table and Base Assembly Exploded View Table and Base Assembly Parts List Index No Description Size QtyCutterhead and Roller Assembly Parts List PGE-B19C Gearbox Assembly Parts List MHA-G Stand and Motor Assembly Parts List PJA-C03 Electrical Connections Page New Sanford Road LaVergne, Tennessee Phone