3M 802, 702 Using the Handheld Device for the first time, See Inserting the memory card on

Page 13

Using the Handheld Device for the first time

Step 1 – Use your system software to export your data and 3M Handheld software onto a memory card. (See your Software User Manual.)

1Install the Handheld software (located on the CD- ROM delivered with the handheld) on the same computer where you installed your system software.

2Export Handheld software onto a memory card.

This occurs automatically whenever you export data to a memory card.

3Insert the memory card into the handheld.

See Inserting the memory card on page 10.

1

Memory

Card

Memory

Card Drive

Use System Software to export Handheld Software onto a memory card

Memory

Card

Insert a memory card

Step 2 – Charge the battery and insert it into the handheld.

1See Charging the battery on page 16.

2Insert the charged battery into the handheld.

Step 3 – Calibrate the screen

1Press the Reset button (located on the bottom of the handheld near the antenna).

2

Charge the battery

Insert a charged battery

 

into the handheld reader

2Follow the instructions to calibrate the screen using the handheld stylus.

Tap Next at the Country/Date/Time screen. Tap Done at the Setup Complete screen.

Step 4 – Load and set up 3M software

1Press and release the trigger on the handheld to load software into RAM (takes approximately 15 seconds) and display the Palm Preferences screen.

Continue to the next step without setting any preferences.

3

Reset

Button

Press the Reset button

Setup 2 of 4

 

In the following screen,

 

you

 

will be asked to tap the

Stylus

shown below. This

center of the target

 

Use the stylus to tap

 

702 026

 

Calibrate the display

If the 3M software does not load, perform the reset procedure on page 12 and try again.

2Press and release the trigger on the handheld again to display the 3M Software Home screen. (You may have to set the time functions before the Home screen appears.)

3Refer to the 3M Handheld Software Manual for Staff and Admin Setup procedures.

4

Trigger

Press and release

Pull the trigger again, the

the trigger and wait

Home screen appears

about 15 seconds for

702_003

the software to load.

 

9

Page 12 Page 14
Image 13
Page 12 Page 14
Contents
3M Security Systems Division Handheld Rfid Reader Model 702 and ModelPage Table of Contents Page Intended Use Safety InformationIt has not been evaluated for other uses To reduce the risk associated with fire and explosion Safety messagesImportant Notes Do not over tighten the antenna adjustment screwBe careful not to damage the handheld Save all the original handheld packing materialsSafety label locations Industry Canada Radio Frequency Rules and Regulations EMC, USA, and Canada ComplianceEMC Compliance Europe Getting Started SpecificationsHandheld components Handheld componentsHandheld includes a menu-driven display screen Controls and indicatorsSee Inserting the memory card on Using the Handheld Device for the first timeCalibrate the screen Database Errors Install a pull tab on the memory cardInserting the memory card Insert the memory cardRemoving the memory card ProcedureSymptoms may include Resetting the handheldTo reset the handheld If pressing the reset button did not work…Formatting a memory card Using Windows to format the memory cardCleaning the handheld Adjusting the antennaStoring the handheld Storing the handheld for less than a weekBattery charging guidelines Battery ManagementChecking the battery charge Low battery warning messagesTo charge a battery Charging the batteryConnect the power supply output to the charger stand RedBattery replacement Replacing the battery3M Service phone numbers Requesting serviceStock Number Description Ordering replacement parts