Parkside PMGS 12 A1 manual Safety advice relating to kickback

l)Never lay the electrical power tool down until after the attachment has come to a complete standstill. The rotat- ing attachment may snag when it comes into contact with the surface and cause you to lose control of the device.

m)Do not have the electrical power tool running while you are carrying it. Your clothing could become trapped by unintention- al contact with the rotating attachment and the tool could be pulled into your body.

n)Clean the ventilation slots on your electrical power tool regularly. The mo- tor’s fan draws dust into the housing. A build-up of metal dust could give rise to an electrical hazard.

o)Never use the electrical

power tool near inflammable materials. Sparks could ignite

these materials.

p)Do not use attachments that require the use of coolants. The use of water or other liquid coolants could result in electric shock.

Safety advice relating to kickback

Kickback is the sudden reaction to a pinched or snagged rotating attachment, such as a grinding disc, grinding pad, wire brush etc. Pinching or snagging results in the rotating attachment coming to an abrupt stop. This causes the electrical power tool (if not controlled) to move in the opposite di- rection to the direction of rotation of the attachment at the point of constraint.

If, for example, a grinding disc is pinched or snags in a workpiece, this can cause the edge of the grinding disc to penetrate the workpiece, become trapped there and either free itself or kickback. The grinding disc moves towards or away from the op- erator, depending on the direction of movement of the disc at the point of constraint. The grinding disc could also break.

Kickback occurs as a result of incorrect use or mis- use of the electrical power tool. It can be prevented by taking the appropriate precautions as described below.

a)Maintain a firm grip on the electrical power tool and position your body and arms to allow you to resist kick- back forces. Always use the auxiliary handle, if provided, to exercise the greatest possible control over kick- back forces or reaction torques as the device builds up to full speed. By taking suitable precautions the operator can control kickback and reaction forces.

b)Do not place your hands near a rotat- ing attachment. If kickback occurs the at- tachment could move over your hand.

c)Avoid positioning your body in the area into which the electrical power tool would move in the event of a kickback. A kickback moves the electrical power tool in the opposite direction to the di- rection of movement of the grinding disc at the point of constraint.

d)Work particularly carefully in the area of corners, sharp edges etc. to avoid the attachment bouncing or snagging on the workpiece. Corners, sharp edges or bouncing have a ten- dency to snag the rotating attachment. This causes loss of control or kickback.

e)Do not use saw-chain woodcarving discs or toothed discs. Such attachments create frequent kickback and loss of control.

Special safety advice relating to grinding and disc-cutting

a)Always use the guard designed for the type of abrasive consumable you are using. Always use abrasive consumables approved for use with your electrical power tool. Abrasive consumables not approved for use with your electrical power tool cannot be adequately guarded and are unsafe.

GB/IE

5