Lubrication

CAUTION:

This servicing should be performed by Makita

This tool required no hourly or daily lubrica- tion because it has a grease-packed lubri- cation system. It should be relubricated after every 6 months of operation. Send the complete tool to Makita Authorized or Factory Service Center for this lubrication service. However, if circumstances require that you should lubricate it by yourself, pro- ceed as follows.

Run the tool for several minutes to warm it up. Switch off and unplug the tool.

Loosen the six screws and remove the han- dle. Note that the top screws are different from other screws.

Disconnect the connector by pulling it

Remove the crank cap using a hex wrench.

Authorized or Factory Service Centers only.

Screws -

CrampIpac

IHex wrench