HOW TO USE Bit grease
0 Coat the drill bit shank head beforehand with a small amount (about 0.5 - 1 g; 0.02 - 0.04 02.) of bit grease. This chuck lubrication assures smooth action and longer service life.
Installing and removingthe drill bit
To install the drill bit, align protrusion
(A)with the red dot, then align the key groove on the drill bit shank with the red dot and insert the drill bit. Now turn the chuck cover 90 degrees.
II
Fig. 1
*T o remove the drill bit, turn the chuck cover until protrusion (A) is aligned with the red dot. Then slip out the drill bit.
|
| I |
|
| |
I |
| I |
Fig. 2
Side grip
0The side grip can be swivelled a full 360 degrees. To set it a t any desired angle, unscrew the grip counterclockwise and swivel to the desired position.
Then tighten it securely. (Keep the grip base in the barrel groove before tighten- ing in place.)
Fig. 3
6