Switch action
Tool speed is increased by increasing pres- | , | |
Speed control screw | ||
sure on the | trigger. To start the tool, |
|
simply pull | the trigger. Release the |
|
trigger to stop.
Fig. t
.A speed control screw is provided so that tool speed (RPM) can be changed a t the fully- pulled trigger position. Turn the speed control screw clockwise (+) for higher speed and counterclockwise
CAUTION:
Before plugging in the tool, always check to see that the trigger switch actuates properly and returns to the "OFF" position when released.
Hammer drilling operation
.Position the drill bit a t the location for the hole, then pull the trigger.
Do not force the tool. Light pressure gives best results. Keep the tool in posi- tion and prevent it from slipping away from the hole.
When holes becomeclogged
.Do not apply more pressure when the hole becomes clogged with chips or par- ticles. Instead, run the tool a t idle, then remove from the hole. By repeating this several times, the hole will be cleaned out completely.
Fig. 9
CAUTION:
When drilling in concrete, it is quite possible that the drill bit could hit a reinforcing rod or some other object that could cause a kickback. Although this tool is equipped with the torque limiter, protect yourself by holding the tool firmly with both hands. (Be sure the side grip is secured tightly before operation.)
8