Miller Electric ICE-27C, 375 manual Troubleshooting Torch, Reset unit Go to Section

6-6. Troubleshooting Torch

Does arc go on and off while cutting?

No

Does arc go out while cutting?

No

Do sparks come out of top of cut; or cut is not clean?

No

Is Trouble light On; unit has no cutting output?

No

Go to Section 6-5.

	Torch travel speed too slow;
	increase travel speed (see
Yes	Section 5-2). Clean or
	replace torch consumables			Go to Section 6-5.
	as necessary (see Section
	6-4). Be sure work clamp is
	securely	attached	to
	workpiece.

	Be sure work clamp is
	securely attached to work-
Yes	piece. Make sure tip is on or
	near, 1/16 in (1.6 mm) to 1/8	Go to Section 6-5.
	in (3.2 mm) workpiece (see
	Section 5-4). Clean or
	replace torch consumables
	as necessary (see Section
	6-4).

	Torch travel speed too fast;
	reduce travel speed			(see
	Section 4-1). Clean or
Yes	replace torch consumables
	as necessary (see Section
	6-4). Be sure work clamp is
	securely	attached		to
	workpiece. Unit not capable
	of cutting	metals	thicker
	than rating	(see	Section
	4-1).

Yes	Check torch shield cup (see
	Section 6-2); reset unit	Go to Section 6-5.
	Power switch. *Check torch
	and connections inside unit.

*Servicing procedure to be performed only by authorized Service Station.

OM-2229 Page 25