Miller Electric ICE-27C, 375 manual Specifications For Torch, Non-CE Model

SECTION 4 − INSTALLATION

4-1. Specifications

NOTE

If the unit is operated from a 30* ampere, 115 volt circuit or a 15** ampere, 230 volt circuit, a different input power plug must be installed on the power cord. See Section 4-9for instructions.

*A 30 ampere branch circuit is recommended for maximum performance. Performance on a 20 ampere branch service may be limited due to the circuit breaker or line fuse. Reducing unit output amperage will minimize circuit breaker tripping or blowing a line fuse.

**A 15 ampere branch circuit is recommended for maximum performance. Performance on a 10 ampere branch service may be limited due to the circuit breaker or line fuse. Reducing unit output amperage will minimize circuit breaker tripping or blowing a line fuse.

A. Non-CE Model

	Amperes Input at
	Rated Output,						Rated
	60 Hz, Single-Phase
						Plasma	Cutting
	115 V	230 V	115 V	230 V	Plasma	Gas Flow/	Capacity	Max
Rated Output	(+15%)	(+15%)	KVA/KW	KVA/KW	Gas	Pressure	at 10 IPM	OCV
27 A at 92 Volts DC At	28 max;	14 max;	3.32 KVA	3.25 KVA	Air Or	4.5 CFM	3/8 in	288 Volts
						(129 L/min)
					Nitrogen
35% Duty Cycle	0.30*	0.13*	3.25 KW	3.19 KW		At 60 PSI	(10 mm)	DC
					Only
						(414 kPa)
*While idling
B. CE Model
	Amperes Input at
	Rated Output,						Rated
	50 Hz, Single-Phase
						Plasma	Cutting
	115 V	230 V	115 V	230 V	Plasma	Gas Flow/	Capacity	Max
Rated Output	(+15%)	(+15%)	KVA/KW	KVA/KW	Gas	Pressure	at 10 IPM	OCV
27 A at 92 Volts DC At	27 max;	13 max;	3.11 KVA	3.04 KVA	Air Or	4.5 CFM	3/8 in	288 Volts
						(129 L/min)
					Nitrogen
35% Duty Cycle	0.33*	0.17*	3.09 KW	3.04 KW		At 60 PSI	(10 mm)	DC
					Only
						(414 kPa)
*While idling
4-2. Specifications For Torch
Air-cooled torch for plasma arc cutting (PAC)
35% duty cycle
Safety interlock devices shut down power source
Safety trigger guard
Cutting capacity: see Section 4-1

OM-2229 Page 11