4-4. Installing And Aligning Wire Guide And Drive Rolls
Installing Wire Guide
And Drive Rolls
5
4 
3
1
2
Installing Wire Guide And Drive Rolls:
1Drive Roll Nut
2Drive Roll Carrier
Turn nut one click until lobes of nut line up with lobes of drive roll carrier.
3 Drive Roll
Slide drive roll onto drive roll carrier. Turn nut one click.
Repeat procedure for top drive roll.
4Inlet Wire Guide Screw
5Inlet Wire Guide
Loosen securing screw. Install inlet guide so inlet guide screw is centered in groove in guide, or so tip is as close to drive rolls as possible without touching. Tighten screw.
Aligning Wire Guide And Drive Rolls:
View is from top of drive rolls look- ing down with pressure assembly open.
6Drive Roll Securing Nut
7Drive Roll
8Wire Guide
9Welding Wire
10Drive Gear
Turn screw in or out until drive roll groove lines up with wire guide.
Close pressure roll assembly.
Aligning Wire Guide And Drive Rolls
Only bottom drive roll alignment is adjustable. Turn adjustment screw in or out until groove in drive roll lines up with wire guide as shown.
Cleaning Drive Rolls:
Remove drive rolls, and clean grooves using a wire brush.
Correct | Incorrect |
8 | 9 |
7
6
10
Tools Needed:
3/16 in
3/8 in
802