Miller Electric Delta-Fab manual Selecting a Location, Tipping, Movement

Page 15

3-4. Selecting A Location

Movement

Location And Airflow	6
	6
3

18 in

(460 mm)

18in

(460 mm)

1Lifting Eye

2Lifting Forks

Use lifting eye or lifting forks to move unit.

If using lifting forks, extend forks beyond opposite side of unit.

3Rating Label (Non CE Models Only)

Use rating label to determine input power needs. Label located under front access door.

4 Plate Label (CE Models Only)

Label located under front access door.

5Rating Label (CE Models Only)

Use rating label to determine input power needs. Label located on rear access door.

6 Line Disconnect Device

Locate unit near correct input pow- er supply.

YSpecial installation may be required where gasoline or volatile liquids are present − see NEC Article 511 or CEC Section 20.

Ref. 800 453-A

3-5. Tipping

Y Be careful when placing or moving unit over uneven surfaces.

OM-2241 Page 11

Image 15

Contents File MIG Gmaw OM-2241209 815HProcesses DescriptionFrom Miller to You Table of Contents Page Electric Shock can kill Symbol UsageMarks a special safety message Arc Welding HazardsBuildup of GAS can injure or kill ARC Rays can burn eyes and skinWelding can cause fire or explosion Flying Metal can injure eyesCalifornia Proposition 65 Warnings Principal Safety Standards EMF InformationAbout Pacemakers UNE Décharge Électrique peut entraîner la mort LES Fumées ET LES GAZ peuvent être dangereuxIndique un message de sécurité particulier DES Pièces Chaudes peuvent provoquer des brûlures graves LE Soudage peut provoquer unIncendie ou une explosion DES Particules Volantes peuvent blesser les yeuxDES Organes Mobiles peuvent provoquer des blessures Risque D’INCENDIE OU D’EXPLOLA Chute DE L’APPAREIL peut blesser ’EMPLOI Excessif peut SUREn ce qui concerne les stimulateurs cardiaques Principales normes de sécuritéOverheating SpecificationsDuty Cycle And Overheating 230Volt-Ampere Curves Movement Be careful when placing or moving unit over uneven surfacesSelecting a Location TippingVAC Receptacle And Supplementary Protectors Dimensions And WeightsDimensions WeightConnecting Weld Output Cables Weld Output Terminals And Selecting Cable SizesDuty Cycle Information Turn off power before con- necting to receptacleRemote 14 Receptacle RC8 Remote 14 Receptacle RC8 InformationInput Amperes At Rated Output Electrical Service GuidePlacing Jumper Links Input VoltageConnecting Input Power Welding Power Source Input Power ConnectionsDisconnect Device Input Power Con- nections Routine Maintenance Disconnect input power before maintaining MonthsControls Disconnect input power be- fore opening rear access door Fuse F1Short Circuit Shutdown Trouble Remedy Troubleshooting Table− Electrical Diagram OM-2241 − Parts List 1Main Assembly Panel, Front w/Components 175 Rectifier, Si Diode SR1Panel, Rear w/Components Support ServiceMiller Electric Mfg. Co Owner’s Record