Miller Electric DS-2 manual Connecting Weld Cable

Page 13

3-8. Connecting Weld Cable

Setscrew

1

2

Connector Body

Sleeve

Weld Cable

 

Insulator

(Male Or Female)

 

 

 

A.Push weld cable through insulator as shown.

B.Remove 1 in. (25 mm) of insulation from end of cable.

C.Install supplied sleeve on stripped end of cable.

D.Insert cable with sleeve into connector body so that cable is snug and against bottom of connector body.

E.Install and tighten setscrew with supplied hex wrench to se- cure connector body onto cable.

F.Push insulator onto connector body to cover setscrew.

1Female Weld Cable Connec- tor (Supplied)

2Weld Cable (Customer Sup- plied)

Select weld cable according to welding power source Owner’s manual.

Install female weld cable connec- tor as shown.

3 Male Weld Cable Connector

Connect male and female weld cable connectors.

3

2

1

Ref. ST-802 483-A

OM-197 509 Page 9

Image 13
Contents DS-2 From Miller to You Table of Contents Page YMarks a special safety message Symbol UsageArc Welding Hazards ARC Rays can burn eyes and skin Fire or Explosion hazard Principal Safety StandardsAbout Pacemakers EMF InformationDefinitions Specifications InstallationSite Selection Installing Wire Guides And Drive Rolls Equipment Connection DiagramsPin Plug PLG1 Information Pin Plug PLG8 InformationPin Plug And Shielding Gas Connections Connecting Weld Cable Changing Nameplates Connecting Welding GunRemove retaining ring. Slide wire Installing Wire Spool And Adjusting Hub TensionWood Threading Welding WirePendant Controls OperationUse Nameplates As a Voltage And Amperage Reference Only Routine Maintenance Maintenance & TroubleshootingTroubleshooting YDisconnect power before maintainingCheck for and remove anything blocking fan movement Circuit Diagram For Wire Feeder Electrical DiagramOM-197 509 Main Assembly Parts ListOptional Pendant Assembly Page Page Support ServiceOwner’s Record