Miller Electric DS-2 manual Connecting Welding Gun, Changing Nameplates

Page 14

3-9. Connecting Welding Gun

1 2

3

4

1 Gun Securing Knob

Loosen knob.

2Gun Block

3Gun End

Slide gun end as far as possible into gun block and tighten gun se- curing knob.

4 Gun Trigger Plug

Connect gun trigger plug to match- ing receptacle on wire feeder.

Ref. ST-802 483-A

3-10. Changing Nameplates

		1	Pendant
		2	Nameplates
	1	Pendant has three nameplates
	1	stacked one on top of the other.
		stacked one on top of the other.
		Each nameplate contains the volt-
	2	age and amperage ranges for a dif-

ferent size flux cored welding wire (for reference only).

Unit is shipped with 1.2 mm wire nameplate on top. To change to 1.4 mm or 1.6 mm wire nameplate, re- move the four screws and bring the desired nameplate to the front. Install the four (4) screws back in place to hold the nameplates.

Tools Needed:

5/16 in

Ref. ST-802 483-A

OM-197 509 Page 10

Image 14

Contents DS-2 From Miller to You Table of Contents Page Arc Welding Hazards Symbol UsageYMarks a special safety message ARC Rays can burn eyes and skin Principal Safety Standards Fire or Explosion hazardEMF Information About PacemakersDefinitions Site Selection InstallationSpecifications Equipment Connection Diagrams Installing Wire Guides And Drive RollsPin Plug And Shielding Gas Connections Pin Plug PLG8 InformationPin Plug PLG1 Information Connecting Weld Cable Connecting Welding Gun Changing NameplatesInstalling Wire Spool And Adjusting Hub Tension Remove retaining ring. Slide wireThreading Welding Wire WoodUse Nameplates As a Voltage And Amperage Reference Only OperationPendant Controls Troubleshooting Maintenance & TroubleshootingRoutine Maintenance YDisconnect power before maintainingCheck for and remove anything blocking fan movement Electrical Diagram Circuit Diagram For Wire FeederOM-197 509 Parts List Main AssemblyOptional Pendant Assembly Page Page Service SupportOwner’s Record