Miller Electric MSC-2 manual Location, Interconnecting And Power Cord Installation

Page 11

SECTION 3 – INSTALLATION

3-1. Location

IMPORTANT: Mount slide so motor and cables are away from weld zone to protect from heat and spatter.

The motorized slide is normally installed onto the cross arm of a side beam opposite the side beam control. An adapter plate is available. The MSC-2 is normally installed behind the side beam control on the cross arm. Brackets are available.

3-2. Interconnecting And Power Cord Installation

				1	Motorized Slide
				2	MSC-2 Control
				3	Interconnecting Cord Plug
	3		4	3	Interconnecting Cord Plug
	3		4	4	Receptacle

Align keyways, insert plug into receptacle, and tighten threaded collar.

5 115 Volts Ac Plug

Connect plug to matching grounded and protected (time delay

1fuses or circuit breakers) 115 volts ac receptacle.

2

RIGHT-LEFT	UP-DOWN
4

3

3

5

Ref. ST-154 578 / ST-098 878-B / Ref. ST-154 602

OM-1096 Page 7

Image 11

Contents Description OM-1096Processes From Miller to You Table of Contents Page Electric Shock can kill Symbol UsageMarks a special safety message Arc Welding HazardsBuildup of GAS can injure or kill ARC Rays can burn eyes and skinWelding can cause fire or explosion Flying Metal can injure eyesPrincipal Safety Standards About Pacemakers EMF InformationLoad Data SpecificationsMotorized Slide Specifications MSC-2 SpecificationsMSC-2 Dimensions Motorized Slide DimensionsLocation InstallationInterconnecting And Power Cord Installation Remote Movement Control Connections Installing Gun Onto Mounting PlateMSC-2 Control OperationOverload Protection Maintenance & TroubleshootingMotorized Slide Limit Switch Routine MaintenanceDrive Belt Adjustment Slide MaintenanceTrouble Remedy TroubleshootingCircuit Diagram For MSC-2 Circuit Diagram For Motorized SlideMotorized Slide Parts ListDia Part MSC-2, Motorized Slide Control Optional OM-1096 Support ServiceMiller Electric Mfg. Co Owner’s Record