DM 2610938876
4. Place the carbon brush and spring back into the tool, there is only one way the brush will fit back into the tool.
5. Replace the brush caps onto the tool by turning the cap in a clockwise direction. To tighten, use the wrench, but DO NOT OVER TIGHTEN!
After replacing the brushes the tool should be run at no load; place it on a clean surface and run it freely at full speed for 5 minutes before loading (or using) the tool. This will allow the brushes to “seat” properly and will give you more hours of life from each set of brushes. This will also extend the life of your tool since the commutator surface will also wear better and longer.
Cleaning The Tool
Ventilation openings and switch levers must be kept clean and free of foreign matter. Do not attempt to clean by inserting pointed objects through openings.
The tool may be cleaned with com- pressed air. Always wear safety goggles when cleaning tool with compressed air.
There is no need to lubricate the Dremel™ rotary tool.
! CAUTION Certain cleaning agents and solvents will damage plastic parts. Some of these are: gasoline,
carbon tetrachloride, chlorinated clean- ing solvents, ammonia and household detergents that contain ammonia.
Clean the “soft grip” areas of the tool using a damp cloth. Tougher soiled areas may require more than one wipe application to get clean.
16