DM 2610938876
ASSEMBLY
! WARNING Always unplug rotary tool before changing accessories, changing collets, or servicing the tool.
| Collets |
|
|
|
|
The Dremel™ accessories available for the |
|
|
|
| |
rotary tool come with various shank sizes. |
|
|
|
| |
Four size collets are available to accommdate | Collet |
|
|
| |
the different shank sizes. Collet sizes are |
|
|
| ||
identified by the rings on the back of the collet: | Nut |
|
|
| |
• 1/32" collet has 1 ring (No. 483) |
|
|
|
| |
• 1/16" collet has 2 rings (No. 482) |
|
|
|
| |
• 3/32" collet has 3 rings (No. 481) |
|
|
|
| |
• 1/8" collet has no rings (No. 480) | 480 | 481 | 482 | 483 | |
NOTE: Some rotary tool kits may not include | |||||
all four collet sizes. Collets are available | 1/8" | 3/32" | 1/16" | 1/32" | |
separately. |
| Collet | Collet | Collet | Collet |
! CAUTION | Always use the collet which matches the shank size of the accessory you | ||||
plan to use. Do not force a larger diameter shank into a smaller collet. | |||||
Changing Collets
1. Press the shaft lock button, hold down and rotate the shaft by hand until it engages the shaft.
! WARNING Do not engage the shaft tool is running.lock button while rotary 2. With the shaft lock button engaged, loosen and remove the collet nut. Use
the collet wrench if necessary.
3. Remove the collet by pulling it free from the shaft.
Collet
Wrench
Shaft Lock
Button
4. Installinto thetheshaftappropriateand reinstallsizethecolletcolletfullynut finger tight. Do not fully tighten the nut when there is no bit or accessory installed.
Changing Accessories
1. Press the shaft lock button and rotate the shaft by hand until it engages the shaft lock.
! WARNING Do not engage the shaft tool is running.lock button while rotary 2. With the shaft lock button engaged, loosen (do not remove) the collet nut.
Use the collet wrench if necessary.
3. Insert the bit or accessory shank fully into the collet.
4. With the shaft lock button engaged, fin- ger tighten the collet nut until the bit or accessory shank is gripped by the collet.
To Tighten | To Loosen | Collet |
|
| Nut |
Shaft Lock
Button
NOTE: Be sure to
read the instructions supplied with your Dremel™ accessory for further information on its use.
9