Craftsman 572.6112 owner manual Cleaning The Tool, Tool Lubrication

MAINTENANCE (CONTINUED)

4. Install existing or new brushes so the	Cleaning The Tool
curved surface of the brush end	Ventilation openings and switch levers must
matches the curvature of the motor	be kept clean and free of foreign matter. Do
commutator (as seen through the brush	not attempt to clean by inserting pointed
opening).	objects through openings.
NOTE: The detent on the brass clip must fit				The tool may be cleaned
into the slot on the side of the brush pocket,				with	compressed air.
which secures the brass clip in the proper				Always wear safety goggles
position (Figure C).				when cleaning tool with
5. Reinstall brush covers by angling the				compressed air.
non-clip end into the opening. Make
certain brush spring is centered in the			Certain cleaning agents
“V” notch on brush, then snap closed
	!	CAUTION
the clip end of the brush cover.			and solvents will damage
6. Plug power cord into a wall outlet. Run	plastic parts. Some of these are:
the rotary tool at full speed for 5	gasoline,		carbon		tetrachloride,
minutes under no load. This will	chlorinated cleaning solvents, ammonia
properly seat the brushes and extend	and household detergents that contain
the life of the tool.	ammonia.
Tool Lubrication	Clean the “soft grip” areas of the tool using a
	damp cloth. Tougher soiled areas may
There is no need to lubricate the rotary tool.	require more than one wipe application to
	get clean.

15