Craftsman 572.6112 owner manual Accessories, Aluminum Oxide Abrasive Grinding Wheel Wheels

Bristle Brushes1/8" shank Bristle brushes are

used for cleaning tools

on silverware, jewelry and antiques. The three shapes make it possible to get into tight corners and other difficult spaces. They can be used with polishing compound for faster cleaning or polishing.

				ACCESSORIES (CONTINUED)
High Speed Cutters						Engraving Cutters	3/32" shank
High speed cutters are					1/8" shank	Engraving cutters come in
used in carving, cutting						a wide variety of sizes and
and slotting wood, plastics						shapes and are used for intricate work on
and soft metals (such as aluminum, copper						ceramics (greenware), wood carvings,
and brass). Made of high quality steel.						jewelry and scrimshaw. They are often used
						in making complicated printed circuit boards.
Structured Tooth Tungsten Carbide Cutters						They should not be used on steel and very
						hard materials, but are good for use on
						wood, plastic and soft metals.
						Tungsten Carbide Cutters	1/8" shank
						Tungsten carbide cutters
		1/8" shank				are long-lived cutters for
						use on hardened steel, fired
These cutters feature fast cutting needle-						ceramics and other very hard materials.
sharp teeth for greater material removal with						They can be used for engraving on tools and
minimum loading. Use on fiberglass, wood,						garden equipment.
plastic, epoxy and rubber.
Wire Brushes			Never use wire brushes at			Brushing Pressure
!	CAUTION
			speeds		greater than	•. The tips of a wire brush do the work.
15,000 rpm. Refer to Speed Settings						Operate the brush with the lightest
(pages 10-12) for proper tool and setting.						pressure so only the tips of the wires
Three different shapes						come in contact with the work surface.
of wire brushes				are		•. If heavier pressure is used, the wires will
available		in	three			become overstressed, resulting in a
different		materials:			1/8" shank	wiping action. If this continues, the life of
stainless steel, brass						the brush will be shortened by fatigue.
and	carbon			wire.		•. Apply the brush to the work surface so
Stainless steel brushes perform well on						the majority of the brush face makes full
pewter, aluminum, stainless steel and other						contact. Applying the edge or side of the
metals, without leaving rust. Brass brushes						brush to the work surface will result in
are non-sparking				and softer than steel,		wire breakage and shortened brush life.
making them good for use on soft metals
like gold, copper and brass. Carbon wire
brushes are good for general purpose
cleaning.

Aluminum Oxide Abrasive		Grinding Wheel
Wheels		Used for deburring, removing rust,
Used to remove paint, deburr		and general purpose grinding.
metal, polish stainless steel	1/8" shank	Use with Mandrel.
and other metals. Available in
medium grit.

17