en
2.12 Using extension cords outdoors
When working outdoors, use only extension cords that are approved and correspondingly marked for this application.
2.13 Using a generator or transformer
This power tool may be powered by a generator or transformer when the following conditions are fulfilled: The unit must provide a power output in watts of at least twice the value printed on the type identification plate on the power tool. The operating voltage must remain within +5% and
Never operate other power tools or appliances from the generator or transformer at the same time. Switching other power tools or appliances on and off may cause undervoltage and / or overvoltage peaks, resulting in damage to the power tool.
In addition, the power tool may not start or may cut out (no LED indication) if the electric supply is not within specifications (see “Troubleshooting” section).
3. Accessories, consumables
TPS Theft Protection System with Company Card,
Company Remote and TPS‑K key (optional)
Use the Hilti chisels or other tools listed below. With these you will achieve higher performance and longer lifetime as the power tool and chisels have been optimized as a system.
| Designation | Width (mm) | Length (mm) | Width in | Length in |
| inches | inches | |||
|
|
|
| ||
|
|
|
|
|
|
Pointed chisels | TE‑H28P |
| 400 |
| 16 |
| SM 40 |
|
|
|
|
| TE‑H28P |
| 500 |
| 20 |
| SM 50 |
|
|
|
|
Flat chisels | TE‑H28P | 38 | 400 | 1¹⁄₂ | 16 |
| FM 40 |
|
|
|
|
| TE‑H28P | 38 | 500 | 1¹⁄₂ | 20 |
| FM 50 |
|
|
|
|
TE‑H28P | 80 | 400 | 3¹⁄₈ | 16 | |
| SPM 8/40 |
|
|
|
|
| TE‑H28P | 80 | 500 | 3¹⁄₈ | 20 |
| SPM 8/50 |
|
|
|
|
Asphalt chisel | TE‑H28P | 125 | 450 | 5 | 18 |
| SPMA 45 |
|
|
|
|
Pointed flat chisel | TE‑H28P | 115 | 500 | 4¹⁄₂ | 20 |
| SPI 50 |
|
|
|
|
Shank | TE‑H28 SS 40 |
| 400 |
| 16 |
Tamping plate | TE STP | 150x150 |
| 6x6 |
|
| 150x150 |
|
|
|
|
| TE STP | 200x200 |
| 8x8 |
|
| 200x200 |
|
|
|
|
4