APPENDIX
Problem: | Try these Solutions | |
Remote Control Unit | ● Check batteries. | |
does not work. | ● Check | |
● Make sure nothing is between Infrared Remote Receiver and Remote Control Unit. | ||
| ||
| ● Make sure you are not too far from a projector when using Remote Control Unit. | |
| Maximum operating range is 16.4’ (5m). | |
| ● Check transmitted signal mode from Remote Control Unit. | |
| (See“SETTING” section on page 39.) | |
Wireless Mouse | ● Check cable connection between a projector and your computer. | |
function does not | ● Check mouse setting on your computer. | |
● Turn a projector on before turning on a computer. | ||
work. | ||
| ||
|
|
SERVICE
WARNING: High voltages are used to operate this projector. Do not attempt to open cabinet.
You can often correct operating problems yourself. If a projector fails to work properly, see "TROUBLESHOOT- ING" section on pages 46, 47. To correct failure, try "Solutions".
If after following all operating instructions, you find that service is necessary, contact Sanyo Service Station or store where you purchased unit.
Give model number and explain difficulty. We will advise you how to obtain service.
This symbol on the nameplate means the product is Listed by Underwriters Laboratories Inc. It is designed and manufactured to meet rigid U.L. safety standards against risk of fire, casualty and electrical hazards.
The CE Mark is a Directive conformity mark of the European Community (EC).
47