Craftsman 315.114071 manual To Install or Remove Battery Pack, Latches, Switch, Tohanger Raise

Page 8

LED FUNCTIONS OF CHARGER LED WILL BE ON TO INDICATE STATUS OF CHARGER AND

BATTERY PACK:

Red LED on = Fast charging mode.

Green LED on = Fully charged and In trickle charge mode,

Green LED on = When bakery pack is Inserted Into charger, indicates hot battery pack or that battery pack is out of or below normal temperature range.

Yellow and Green LEDs on = Deeply discharged or defective battmy back.

No LED on = Defective chargeror battery pack.

,_ CAUTION: To prevent damage to battery back, remove battery pack from charger Immediately If no

LED comes on. Return battery back and charger to your nearest Sears Service Center for checking or replacing,Also, if you are removing battery packfrom charger and no LEDs are on, return both battery pack and charger to your nearest Sears Service Center, Do not Insertanother battery pack Into charger. A damaged charger may damage a battery pack,

TO INSTALL OR REMOVE BATTERY PACK

See Figure2.

Use only the recommended battery pack with your light.

WARNING: Do not install battery back to your light untilyou have read and understoodall ixecautions and operating InstructionsIn the manual and printed on battery pack and charger,

LATCHES

BATrERY PACK

Fig. 2

IIOrient battery pack so that raised rib on battery pack aligns with groove Inside light. Battery pack is de- signedto fit only one way Into light handle,

Insert battery pack, making sure latches on each side of battery pack snap Into place and battery pack is secure In light before use.

A CAUTION: When placingbattery pack In your light, be sure raised ribon battery back aligns with groove Inside lighthandle and latches snap Into place properly.Improper assembly of battery pack can cause damage to Internal components.

To remove battery pack, locate latches on end of battery pack and depress to release battery packfrom your light.

SWITCH

See Figure 3.

To turn lighton and off, depress switchtrigger.

SWffCH

Fig. 3

HANGING I STORAGE FEATURE

See Figure 4.

On top of the housing Is a hook In which you can use to hang the light up. This Is a good feature for stodng light when not In use and also to keep lightout of the reach of children. To use, simply lift up on hook.

TOHANGER

RAISE

TO

Flq 4

Image 8
Contents OperatorsManual Full ONE Year Warranty on Craftsman Fluorescent Light Electrical Safety Personal SafetyService Savetheseinstructions Work AreaUSE only the Charger Recommended for Important Rules for Battery ToolsAdditional Rules for Safe Operation Important Safety Instructions for Charger Symbol Name Desig NATION/EX Planation Symbol MeaningBattery Pack Charging Battery PackImportant Information for Recharging HOT Battery Pack Batfery PACK/CHARG ERTo Install or Remove Battery Pack SwitchHanging I Storage Feature LatchesFluorescent Tube Replacement To Replace Fluorescent TubePull Lens Cover Rubber Forward to Remove Cushion Screw Fluorescent Tube BulbBattery Pack Removal and Preparation for Recycling BaiferiesPage 8EAUR