BATFERY PACK/CHARG ER
If not purchased as a kit, the battery pack and charger are not included with your light. They are both sold sepa-
rately, if you need to purchase the battery pack and charger, use the following information:
MODEL NO. | BAI"rERY PACK | CHARGER | |
315.114071 | Item No. a 11375 | Item No._ 11041 | |
| (1323517or | 1323903) | (1425301) |
BATTERY PACK
The battery pack for this tight has been shipped In a low
charge condition to prevent possJble problems. Therefore, you should charge it until light on front of charger changes from red to green.
Note: Batteries will not reach full charge the first time they are charged. Allow several cycles (operetlng light followed
by recharging) for batterles to become fully charged.
CHARGING BATTERY PACK
See Figure 1.
•Use onlythe recommendedbattery pack and charger withthe light.
•Make sure power supply is normal household voltage, 120 Volts, 60 Hz, AC only.
•Connect chargerto power supply,
•Place battery pack in charger aligning raised rib on battery back with groove in charger. See F(gure 1.
•Preessdo,vnon batterypackto be sumcontactson battery packengageIzoparlywithcontactsIncharger.
•Normally, the red LED on charger will come on.This Indicates charger is in fast charging mode.
•Red LED shouldremain on for apprc0<imately1 hour then the green LED will come on. Green LED on indicates battery pack is fullycharged and charger is in trickle charge mode. Note; Green LED will remain on untilbattery pack is removed from charger or charger Is dlsconneeeedfrom power supply.
•If b_h yellowand green LED come on, this Indicates a deeply discharged or defectivebattery pack.
Allow battery packto remain in charger for 15 to 30 minutes. When battery pack reaches normal voltage range, red LED shouldcome on.
If red LED does not come on alter 30 minutes,this indicatesa defective battery pack and shouldbe
replaced.
After normal usage, a minimumof 1 hour of charging
time is required to fully recharge battery pack,
The battery pack will become slightlywarm to the touch while charging.This is normal and does nee indicatea problem.
Do not piace charger and battery pack in an area of extreme heat or cold, Itwill work best at normal room
temperature.
Note: Charger and battery pack should be placed in a Icoatlon where the temperature Is more than 50°F but less than IO0°F.
When batteriesbecome fully charged, unplugcharger from power supplyand remove the battery pack.
IMPORTANT INFORMATION FOR RECHARGING HOT BATTERY PACK
When using the light continuously, the batteries in the battery pack will become hot. You should let a hot battery pack cool down for approximately 30 minutes before attemptingto recharge. When the battery pack becomes
discharged and Is hot, this will cause the green LED to come on instead at the red LED, After 30 minutes, reinsert
battery pack In charger. If green LED continues to remain on, return battery pack to your nearest Sears Repair Center for checkingor replacing.
Note; This situationonly occurs when continuous use of
your light causes the batteries to become hot. It does not occur under normal drcumstances. Refer to "CHARGING
BATTERY PACK" for normal rechargingof batteries. If the charger does no_charge the battery pack under normal circumstances,return both the battery pack and charger to the nearest Sears Repair Center for electrical check.
BATrERY PACK
SHOWN IN CHARGER
CHARGER
RED LED ON INDICATES
FAST CHARGING •ODE
GREEN LED ON AFTER FAST CHARGING
CYCLE, INDICATES FULLY CHARGED BATTERY PACK AND IN TRICKLE CHARGE MODE.
YELLOW AND GREEN LEDS ON INDICATES DEEPLY DISCHARGED OR DEFECTWE BATFERY PACK.
Fig, 1