Grizzly H7761 owner manual Lubricating Sleeve Bearings, To lubricate the sleeve bearings

Page 24

Lubricating Sleeve

Lubricate the sleeve bearing with 30 WT oil every 10 hours of operation. No other lubrication is nec- essary for this machine.

2.Remove the sanding belt.

3.Apply two or three drops of oil in the hole at the end of the idler pulley (Figure 15).

4.Wipe of any residual oil.

Note: DO NOT apply extra oil. Too much oil can cause the belt to slip.

-22-	H7761 2" x 27" Belt & 6" Disc Combo Sander

Image 24

Contents Model H7761 Page Table of Contents Introduction ForewordContact Info Overall Dimensions FeaturesMotor Identification Safety Safety Instructions for MachineryAlways Lock Mobile Bases if Used Before Operating Machinery Additional Safety Instructions for Sanders Circuit Requirements 110V OperationSET UP Set Up Safety InventoryUnpacking Inventory Figure QtyItems Needed for Set Up MountingDescription Qty Components and Hardware Required QtyHardware Recognition Chart Clean Up Weight LoadSite Considerations Working ClearanceInstalling Disc Table To install the disc tableAttaching Sanding Disc Components and Hardware Needed QtyAdjusting Miter Gauge To adjust miter gaugeAligning Table To align the tableTo install the sanding belt To test the trackingInstalling Back Stop Installing Dust Collection HoseTo install the back stop To connect a dust port to a dust collection systemOperations GeneralDisc Sanding Miter Sanding Angle Sanding To perform miter sanding operationsTo perform angle sanding operations Belt Sanding To perform belt sanding operationsAccessories H1300 H1298 G7984 H2347 H073627 Silicon Carbide Sanding Belts Aluminum Oxide Sanding DiscsMaintenance Maintenance SafetySchedule Lubricating Sleeve Bearings To lubricate the sleeve bearingsService TroubleshootingBreakdown Parts List DescriptionWarranty and Returns Page Page