3.Loosen the angle knobs and adjust the table angle until there is no gap between the disc face and the square.
4.Tighten the angle knobs while holding the table perpendicular.
Aligning Table
The table must be aligned to the face of the sanding disc so that the sandpaper does not rub against the table.
To align the table:
1.DISCONNECT THE MACHINE FROM THE POWER SOURCE!
2.Loosen the knobs that secure the table to the sanding unit.
3.Adjust the table so that there is 3⁄64" or 1 mm between the table and the sanding disc as shown in Figure 6.
3⁄64" Gap
Figure 6. The gap between the table and the disc.
4.Tighten the knobs loosened in Step 2.
5.Spin the disc by hand to check if the sandpa- per is touching the table.
6.Repeat Steps 2-4 if the sandpaper touches the table at any point in the rotation.
Adjusting Miter Gauge
The miter gauge needs to be adjusted perpendic- ular to the face of the wheel when it is mounted in the table slot.
To adjust miter gauge:
1.DISCONNECT THE MACHINE FROM THE POWER SOURCE!
2.Use a machinist square with one edge against the face of the miter gauge and the other against the disc face as shown in
Figure 7.
Figure 7. Squaring the miter gauge.
3.Loosen the lock knob on the miter gauge to adjust it flush with the edge of the square.
4.Tighten the lock knob and verify the setting.
Note: Sometimes the tightening procedure can affect the adjustment.