Husqvarna PG680, PG820 manuel dutilisation EC-declaration of conformity

Page 27

Technical Data

EC-declaration of conformity

(Applies to Europe only)

Husqvarna Construction Products, SE-433 81 Göteborg, Sweden, tel: +46-31-949000, declares under sole responsibil- ity that the Husqvarna PG680/PG820 dating from 2007 serial numbers and onwards (the year is clearly stated on the rating plate, followed by the serial number), complies with the requirements of the COUNCILíS DIRECTIVE:

-of June 22, 1998 ”relating to machinery” 98/37/EC, annex IIA.

-of May 3, 1989 ”relating to electromagnetic compatibility” 89/336/EEC, and applicable supplements.

-of December 12, 2006 ”relating to electrical equipment” 2006/95/EC.

The following standards have been applied: EN 55014-1, EN55014-2, EN61000-3-2, EN61000-3-3.

The supplied machine conforms to the example that underwent EC type examination.

Göteborg 16 July 2007

Tim Van Der Veen, Development Manager

English - 29

Image 27

Contents Manuel d’utilisation Operator’s manualManual de instrucciones BedienungsanweisungEnglish ContentsKey to symbols Safety Instructions Introduction TransportationStorage What is what Control panel Setting up/Operation Powering up machineSetting Speed and direction REV Application Planetary Grinding discDirection Speed FWDChanging the diamonds PreparationChanging Protection/Diagnostic Protection FunctionalKeypad/Display Monitor screen Information provided Variable speed drives/frequency convertersMenus and information they provide Fault HistoryFault Code Possible Cause Action Faults and trouble shootingOnto Problem Possible Cause Potential SolutionSummary of diamond principles DiamondsBackground General PrinciplesGrinding disc set-up Diamond selectionApplication Full set is best Half set is best Full and half sets of diamondsHALF-SET of Diamonds FULL-SET of DiamondsHard Selecting the correct diamonds for your applicationSoft MediumDetermining the hardness of concrete Maintenance Grinding headsCONVENTIONAL/DEMOLITION Heads Spring Steel Heads DiagramPlanetary Drive System Grinding Heads Drive SystemRemove this bolt Maintenance schedule Action Frequency Maintenance scheduleTechnical Data EC-declaration of conformity ´z+R~@¶0R¨ 2007-08-23´z+R~@¶0R¨