Grizzly T10222 owner manual Assembly, To assemble and install your router table attachment

Page 11

Assembly

The Model T10222 mounts on most table saws that have 27" deep tables. If your table saw does not have mounting holes for the installation of the router table, you will need to drill and tap these holes. Also, you may have to modify the fence rails to allow access for the router table T-slots. Read this entire assembly section before begin- ning the installation procedure below to make sure the T10222 will fit your table saw.

To assemble and install your router table attachment:

1.DISCONNECT THE TABLE SAW FROM POWER!

2.Decide which of the following mounting options best suits your needs:

—Remove the existing right wing of the saw table and use the existing wing mounting holes to attach the router table.

—Mount the router table to the right side of the saw table or the existing right-hand wing. In these cases, you will probably need to drill and tap three M8-1.25 holes into the saw table or wing that match those in the router table (see Figure 6).

Tip: Use the holes in the router table as a template for marking the mounting hole loca- tions on the saw table so that the router table top will mount flush with the top of the saw table.

Model T10222 (Mfg. Since 12/09)

Saw Table

Mounting Holes

Router Table

Figure 6. Required mounting holes in the router

and saw tables.

3.Thread the foot pad assembly into the bottom of the support leg, as shown in Figure 7. For now, do not tighten the jam nut up to the leg so that you can adjust the height of the leg in a later step.

Foot Pad

 

Support

Jam Nut

Leg

Figure 7. Foot pad threaded into the support leg.

-9-

Image 11
Contents Router Table Attachment Page Important Notice Table of ContentsTool Description IntroductionManual Accuracy Contact InfoMachine Data Sheet Safety Instructions for Machinery SafetyUnattended OPERATION. Never­ leave­ Additional Safety for Router Tables Description Qty SetupNeeded for Setup UnpackingShipping inventory items A-B InventoryTo assemble and install your router table attachment AssemblyCut-Out Knurled fence handles installed Guard bracket attached to the fence To install a router Router InstallationOperation Overview OperationsWorkpiece Inspection To joint the edge of a workpiece Edge JointingTo make a zero-clearance fence Groove CuttingRouting Small Stock To cut a groove into the face of the workpieceFree-Hand Routing To free-hand route Example of using a jig with a starting BlockDaily Check MaintenanceCleaning Protecting ScheduleTable Parts PartsFence Parts Comments Warranty CardBOX BELLINGHAM, WA Grizzly INDUSTRIAL, INCWarranty and Returns Warranty and ReturnsOrder Hours a DAY