Table of Contents, Important Notice

Table of Contents
INTRODUCTION
Manual Accuracy	2
Contact Info	2
Tool Description	2
Specifications	3
SECTION 1: SAFETY
Safety Instructions for Machinery	4
Additional Safety for Router Tables	6
SECTION 2: SETUP
Needed for Setup	7
Unpacking	7
Inventory	8
Assembly	9
Router Installation	13
SECTION 3: OPERATIONS
Operation Overview	14
Workpiece Inspection	15
Edge Jointing	16
Groove Cutting	17
Routing Small Stock	17
Free-Hand Routing	18
SECTION 4: MAINTENANCE
Schedule	20
Cleaning & Protecting	20
SECTION 5: PARTS
Table Parts	21
Fence Parts	22
WARRANTY AND RETURNS	25

IMPORTANT NOTICE!

Table Saw Modifications Required for Installation

The Model T10222 can be installed on most table saws that have 27" deep tables; however, installation usually requires permanent modification to your table saw or its parts. This modification may include cut- ting, grinding, drilling, and tapping threads in metal surfaces. Read the following to determine which type of modification may be required for your saw:

•If your saw table or wing does not have mounting holes that match those in the Model T10222, you will need to drill and tap new holes in the saw table or wing.

•If the fence rails on your saw prevent installation of the Model T10222, then you will need to either:

—Cut off the ends of the rails (this is the easiest and fastest option).

—Re-mount the rails farther to the left, which may also require you to drill (and possibly tap) new holes in your table and cut small notches into your rails for access to T-slots in your saw’s table.

Before beginning any modification to your table saw or its parts, read the entire assembly section in this manual to make sure the person making the modification is capable of performing the required tasks, and to make sure the Model T10222 will fit your saw.