Grizzly T10222 owner manual Knurled fence handles installed

—If the outside edge of the router table tilts up, place strips of masking tape along the top edge of the saw table to shim the router table down and even with the saw table from side to side (see Figure 12).

Note: After reinstalling the router table, remove all excess masking tape with a razor blade.

Tape

Figure 12. Masking tape to ship the table down.

8. When the saw and router tables are level with each other, rotate the foot pad assembly so that it sits firmly on the floor without changing the height of the router table. Tighten the jam nut of the foot pad assembly up to the leg bottom to secure the setting.

9.Slide the two T-slot bars into the T-slots of the router table (see Figure 13).

Note: The router table double-cross T-slots offer two different orientations for the router fence—choose the one that best suits your operation.

T-Slot

Bars

Figure 13. T-slot bars installed.

Model T10222 (Mfg. Since 12/09)

10.Place the fence assembly over the studs of the T-slot bars, then secure the fence in place by threading the knurled handles onto the studs, as shown in Figure 14.

Knurled Fence Handles

Figure 14. Knurled fence handles installed.

Note: The two fence board shims provided with your router table can be placed between the outfeed fence board (left) and the fence to offset the outfeed fence board for full edge routing (see the illustration in Figure 15 and refer to Edge Routing on Page 16 for addi- tional details).

With additional shop-made shims, the outfeed fence board can be offset up to approximate- ly 4mm from the infeed board. If you require more offset, you can obtain longer M6-1 flat head screws to secure the outfeed fence board.

Fence

Shims

Outfeed

Fence Board

Figure 15. Shim installation for full edge routing.

-11-