4.Connect an air compressor to the regulator. Air pressure must be 90 pounds per square inch.
5.To raise the air pressure, lift the air unit cap and turn it counterclockwise as shown in
Figure 5.
Cap
Lube Valve
Figure 5. Lift and turn cap to adjust air pressure. Turn lube valve to lubricate foot switch control.
Chip Blower
The air line control is used to check and control air flow to the chip blower.
1.Turn control on and off to see if pressure exists as shown in Figure 6.
2. Adjust flow to most effectively remove chips from the line of sight.
Figure 6. Air line control for chip blower.
Compressed air can be very dangerous if not handled carefully. Never point an air hose nozzle or blower towards any person, including yourself. Failure to comply with this caution could result in serious injury.
|
|
|
|
|
|
|
|
|
|
|
|
G8030 3 H.P. Overarm Router | |||