Installing the Brake
Handle
The hand brake serves to stop the spindle when repositioning the workpiece. The machine must be turned off before you begin applying the brake to the spindle
1.Slide the brake lever into its hole as shown in Figure 11.
2.Tighten the hex head nut to hold the brake lever in place.
NOTICE
Always turn off the power switch before applying the hand brake. Applying the brake does not disengage the power switch. Failure to do so will result in damage to the braking mechanism.
Always stop the spindle with the brake, or allow it to come to a complete stop before moving hands near the spindle.
Lock Screw
Figure 11. Installed brake lever.
Installing the Fence
The fence is used for straight routing and is easi- ly installed and removed.
1.Place the fence at the location in which it is to be used as shown in Figure 11.
2.Assemble and tighten the fence lock as shown in Figure 12.
3. Assemble and tighten the fence lock on the other side of the table.
Figure 12. Fence lock in place.
|
|
|
|
|
|
|
|
|
|
|
|
G8030 3 H.P. Overarm Router | |||