Grizzly G8030 instruction manual Beginning Assembly Power Panel

SECTION 4: ASSEMBLY

Beginning Assembly Power Panel

All die-cut metal parts have a sharp edge (called “flashing”) on them after they are formed. This is removed at the factory. Sometimes, though, a bit of flashing might escape inspection. Please examine the edges of all die-cut metal parts before han- dling them or serious injury may occur.

!	Disconnect power to the
	machine when perform-
	ing	any	maintenance,
	assembly		or	adjust-
	ments. Failure to do this
	may	result in		serious
	personal injury.

Keep loose clothing rolled up and out of the way of machinery and keep hair pulled back.

Wear safety glasses dur- ing the entire assembly process. Failure to com- ply may result in serious personal injury.

Most of your Model G8030 Overarm Router has been assembled at the factory, but some parts must be assembled or installed after delivery. We have organized the assembly process into steps. Please follow along in the order presented here.

TOOLS REQUIRED: You will need a straight- edge, 12mm, 14mm, 15mm open end wrenches, and a 3 mm Allen® wrench.

The power panel at the rear of the Model G8030 must be properly wired with a safe ground. The green wire is the ground wire and is usually the wire on the right when facing the panel as shown in Figure 2. Please read Section 2: Circuit Requirements for further information on wiring.

Figure 2. G8030 power panel, with ground wire

on right.

-10- G8030 3 H.P. Overarm Router