Bit Tightening |
| Installing the Shield |
|
|
|
|
|
|
The installed router bit must be carefully tight- ened. Two open end wrenches are supplied with the machine.
1.Place one wrench on the flats of the spindle as shown in Figure 9.
2.Place the second wrench on the collet nut.
3. Turn until tight.
Figure 9. Tightening the collet nut.
Do not use the spindle brake to tighten the collet nut. The collet nut must be secured using the two supplied wrenches. If the col- let nut is not secured properly, the bit could fly out of the collet like a bullet. Serious per- sonal injury could result.
The dust shield also serves to help keep chips away from the operator’s face. Installation is quick.
1.Slide the shield onto its post and place the post in its guide hole on the side of the head.
2.Install the hex head bolt in the bottom of the post. Use a flat washer between the bolt head and the shield as shown in Figure 10.
3. Swing the dust shield into place and tighten it with the hand screw.
Figure 10. Securing the dust shield.
|
|
| G8030 3 H.P. Overarm Router |
|
|
| |
|
| ||
|
|