Grizzly G0528 Fence Hold-Downs, To attach the fence assembly, To attach the hold-downs

Fence Hold-Downs

Components Needed:	Qty
Left Fence	1
Right Fence	1
Dust Hood	1
Fence Lock Handles	2
Tools Needed:
10mm Wrench or Socket	1
11mm Wrench or Socket	1
To attach the fence assembly:

1.Secure the left and right fence assemblies to the table with the fence lock handles. Note—Use the holes located closest to the edge of the cast iron table.

2.Secure the dust hood to the top of each fence assembly (Figure 9).

Dust Hood

Figure 9. Installed fence and dust hood.

Components Needed:	Qty
Workpiece Hold-Down Assemblies	....................2
Tools Needed:
19mm Wrench	1
To attach the hold-downs:

1.Remove one of the hex bolts from each of the hold-down brackets.

2.Slide the hold-down brackets through the mounting holes on the dust cover and secure

them from the underside of the dust cover with the hex nuts removed in step 1.

3.Tighten the hex nuts until the hold-down brackets are secure.

4.Secure the hold-down finders to the hold-

down brackets by tightening the threaded star knob (Figure 10). Note—Do not worry about precise placement of the hold-down brackets or fingers at this time.

Workpiece Hold-

Down Assemblies

Threaded Star

Knobs

Figure 10. Installed hold-down assemblies.

-14- G0528 Sliding Router Table