Grizzly G0528 instruction manual Groove cutting, Profile cutting

4.Raise the bit to a height slightly higher than that of the board thickness.

5.Adjust the infeed fence to the right of the

outfeed fence, so that the distance is equal to the desired depth of cut (Figure 17).

Depth Of Cut

Figure 17. Jointing setup.

(Top View)

Groove cutting:

Beading is commonly defined as cutting a groove or bead in the face of a board.

1.Mount a router bit into your router according to the router manufacturer’s instructions.

2.Snap the smallest table insert into the recessed hole that still allows the router bit to freely rotate.

3.Raise the router bit to the desired height.

4.Adjust the main fence until the center of the

V-groove bit is the desired distance away as shown in Figure 18 & 19.

Distance From

Edge Of Board

To Center Of

V-Groove

Figure 18. Groove cutting setup.

(Top View)

Distance From

Edge Of Board

To Center Of

V-Groove

	Figure 19. Groove cutting setup.
	(Side View)
Profile cutting:
Profile cutting is usually performed using a bit
with a ball bearing. The ball bearing is used to
control the depth of cut into the edge face of a
board. A good example would be a chamfer cut.
The bearing rides along the uncut edge of the
board while the cutter removes the wood.
1.	Mount a router bit into your router according
	to the router manufacturer’s instructions.
2.	Snap the smallest table insert into the
	recessed hole that still allows the router bit
	to freely rotate.

G0528 Sliding Router Table -19-