Cisco Systems AIRCAP702IAK9 specifications Vcci Statement for Japan, Usa

Page 14

Manufacturer:

Cisco Systems, Inc.

170 West Tasman Drive

San Jose, CA 95134-1706

USA

This device complies with Part 15 rules. Operation is subject to the following two conditions:

1.This device may not cause harmful interference, and

2.This device must accept any interference received, including interference that may cause undesired operation.

This device operates in the 5150-5250MHz and 5470-5725MHz bands and is therefore restricted to indoor operation only per FCC guidance.

This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a residential environment. This equipment generates, uses, and radiates radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference. However, there is no guarantee that interference will not occur. If this equipment does cause interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to correct the interference by one of the following measures:

•Reorient or relocate the receiving antenna.

•Increase separation between the equipment and receiver.

•Connect the equipment to an outlet on a circuit different from which the receiver is connected.

•Consult the dealer or an experienced radio/TV technician.

Caution The Part 15 radio device operates on a non-interference basis with other devices operating at this frequency when using the integrated antennas. Any changes or modification to the product not expressly approved by Cisco could void the user’s authority to operate this device.

Caution Within the 5.15 to 5.25 GHz and 5.47-5.725 GHz bands, this device is restricted to indoor operations to reduce any potential for harmful interference to co-channel Mobile Satellite System (MSS) operations.

VCCI Statement for Japan

Warning

This is a Class B product based on the standard of the Voluntary Control Council for Interference from Information Technology Equipment (VCCI). If this is used near a radio or television receiver in a domestic environment, it may cause radio interference. Install and use the equipment according to the instruction manual.

14

Page 13 Page 15
Image 14
Page 13 Page 15
Contents Cisco Aironet 700 Series Access Points About this Guide Introduction to the Access PointSafety Instructions 20A. Statement Unpacking ConfigurationsAccess Point Ports and Connectors Access Point LED Indicator top Configuring the Access Point Access Point Ports and Connections bottomController Discovery Process Performing a Pre-Installation Configuration Preparing the Access PointInstallation Summary Pre-Installation Configuration SetupController Layer 3 devices Cisco Aironet access points Mounting the Access Point Deploying the Access Point on the Wireless NetworkChecking the Access Point LED TroubleshootingUsing Dhcp Option Troubleshooting the Access Point Join Process Declarations of Conformity and Regulatory Information ModelsVcci Statement for Japan USAEnglish Translation Statement 371-Power Cable and AC AdapterJapanese Translation Industry Canada Canadian Compliance Statement French TranslationModels Declaration of Conformity for RF Exposure Generic Discussion on RF Exposure This Device Meets FCC Guidelines for Exposure to Radio WavesAdditional Information on RF Exposure Chinese Translation English Translation Chinese Translation English Translation Access Point Models Configuring Dhcp Option 43 and Dhcp OptionOperation of Cisco Aironet Access Points in Brazil Declaration of Conformity StatementsAccess Point Specifications Add the option 60 line using the following syntaxObtaining Documentation and Submitting a Service Request
Top Page Image Contents