Cisco Systems AIRCAP702IAK9 specifications Preparing the Access Point, Installation Summary

Page 8

Preparing the Access Point

Before you mount and deploy your access point, we recommend that you perform a site survey (or use the site planning tool) to determine the best location to install your access point.

You should have the following information about your wireless network available:

•Access point locations.

•Access point mounting options: below a suspended ceiling, on a flat horizontal surface, or on a desktop.

Note You can mount the access point above a suspended ceiling but you must purchase additional mounting hardware: See “Mounting the Access Point” section on page 10 for additional information.

•Access point power options: power supplied by the recommended external power supply (Cisco AIR-PWR-B), a DC power supply, PoE from a network device, or a PoE power injector/hub (the Cisco-recommended injector is the AIR-PWRINJ5=), usually located in a wiring closet.

Note Access points mounted in a building’s environmental airspace must be powered using PoE to comply with safety regulations.

Cisco recommends that you make a site map showing access point locations so that you can record the device MAC addresses from each location and return them to the person who is planning or managing your wireless network.

Installation Summary

Installing the access point involves these operations:

•Performing a pre-installation configuration (optional)

•Mounting the access point

•Grounding the access point

•Deploying the access point on the wireless network

Performing a Pre-Installation Configuration

The following procedures ensure that your access point installation and initial operation go as expected. A pre-installation configuration is also known as priming the access point. This procedure is optional.

Note Performing a pre-installation configuration is an optional procedure. If your network controller is properly configured, you can install your access point in its final location and connect it to the network from there. See the “Deploying the Access Point on the Wireless Network” section on page 10 for details.

Pre-Installation Configuration Setup

The pre-installation configuration setup is shown in Figure 3.

8

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Cisco Aironet 700 Series Access Points About this Guide Introduction to the Access PointSafety Instructions 20A. Statement Unpacking ConfigurationsAccess Point Ports and Connectors Access Point LED Indicator top Configuring the Access Point Access Point Ports and Connections bottomController Discovery Process Preparing the Access Point Installation SummaryPerforming a Pre-Installation Configuration Pre-Installation Configuration SetupController Layer 3 devices Cisco Aironet access points Mounting the Access Point Deploying the Access Point on the Wireless NetworkChecking the Access Point LED TroubleshootingUsing Dhcp Option Troubleshooting the Access Point Join Process Declarations of Conformity and Regulatory Information ModelsVcci Statement for Japan USAEnglish Translation Statement 371-Power Cable and AC AdapterJapanese Translation Industry Canada Canadian Compliance Statement French TranslationModels Declaration of Conformity for RF Exposure Generic Discussion on RF Exposure This Device Meets FCC Guidelines for Exposure to Radio WavesAdditional Information on RF Exposure Chinese Translation English Translation Chinese Translation English Translation Configuring Dhcp Option 43 and Dhcp Option Operation of Cisco Aironet Access Points in BrazilAccess Point Models Declaration of Conformity StatementsAccess Point Specifications Add the option 60 line using the following syntaxObtaining Documentation and Submitting a Service Request
Top Page Image Contents