Cisco Systems AIRCAP702IAK9 specifications About this Guide, Introduction to the Access Point

Page 2

1About this Guide

This Guide provides instructions on how to install and configure your Cisco Aironet 700 Series Access Point. The 700 Series Access Point is referred to as the 700 series or the access point in this document.

2Introduction to the Access Point

The 700 series supports high-performing two spatial stream rates over a deployable distance with high reliability when serving clients. The 700 series provides high reliability and overall wireless performance.

The 700 series offers dual-band radios (2.4 GHz and 5 GHz) with integrated internal antennas. The access point supports full inter-operability with leading 802.11n clients.

The 700 series access point is available in the controller-based configuration and supports:

•Simultaneous dual-band (2.4 GHz/5 GHz) radios

•Integrated antennas on 702I access point models (AIR-CAP702I-x-K9)

Note The ‘x’ in the model numbers represents the regulatory domain. Refer to “Regulatory Domains” section on page 4 for a list of supported regulatory domains.

The features of the 700 series are:

•Processing sub-systems (including CPUs and memory) and radio hardware which supports:

–Unified

–FlexConnect

–Monitor-mode

•The following processor features:

–128 MB NAND flash size

–1 MB NOR flash size

–128 MB DDR2 memory bus, x32

•2.4 GHz and 5 GHz 802.11n radios with the following features:

–802.11n standard compliant

–A-MPDU TX

–HT Duplicate Mode

–2TX x 2RX

–2-spatial streams, 300 Mbps PHY rate

–Maximal ratio combining (MRC)

–Cyclic Shift Diversity (CSD)

–MCS0-MCS15; Short or Long Guard Intervals

–DFS for UNII-2 and UNII-2 Extended channels, including 0.5us radar pulse detection

3Safety Instructions

Translated versions of the following safety warnings are provided in the translated safety warnings document that is shipped with your access point. The translated warnings are also in the Translated Safety Warnings for Cisco Aironet Access Points, which is available on Cisco.com.

2

Page 1 Page 3
Image 2
Page 1 Page 3
Contents Cisco Aironet 700 Series Access Points About this Guide Introduction to the Access PointSafety Instructions 20A. Statement Unpacking ConfigurationsAccess Point Ports and Connectors Access Point LED Indicator top Configuring the Access Point Access Point Ports and Connections bottomController Discovery Process Performing a Pre-Installation Configuration Preparing the Access PointInstallation Summary Pre-Installation Configuration SetupController Layer 3 devices Cisco Aironet access points Mounting the Access Point Deploying the Access Point on the Wireless NetworkChecking the Access Point LED TroubleshootingUsing Dhcp Option Troubleshooting the Access Point Join Process Declarations of Conformity and Regulatory Information ModelsVcci Statement for Japan USAEnglish Translation Statement 371-Power Cable and AC AdapterJapanese Translation Industry Canada Canadian Compliance Statement French TranslationModels Declaration of Conformity for RF Exposure Generic Discussion on RF Exposure This Device Meets FCC Guidelines for Exposure to Radio WavesAdditional Information on RF Exposure Chinese Translation English Translation Chinese Translation English Translation Access Point Models Configuring Dhcp Option 43 and Dhcp OptionOperation of Cisco Aironet Access Points in Brazil Declaration of Conformity StatementsAccess Point Specifications Add the option 60 line using the following syntaxObtaining Documentation and Submitting a Service Request
Top Page Image Contents