Cisco Systems AIRCAP702IAK9 specifications 20A. Statement

Page 3

Warning

IMPORTANT SAFETY INSTRUCTIONS

Warning

Warning

Warning

Warning

Warning

Caution

Caution

Note

Note

This warning symbol means danger. You are in a situation that could cause bodily injury. Before you work on any equipment, be aware of the hazards involved with electrical circuitry and be familiar with standard practices for preventing accidents. Use the statement number provided at the end of each warning to locate its translation in the translated safety warnings that accompanied this device. Statement 1071

SAVE THESE INSTRUCTIONS

Read the installation instructions before you connect the system to its power source. Statement 1004

Installation of the equipment must comply with local and national electrical codes. Statement 1074

This product relies on the building’s installation for short-circuit (overcurrent) protection. Ensure that the protective device is rated not greater than:

20A. Statement 1005

Do not operate your wireless network device near unshielded blasting caps or in an explosive environment unless the device has been modified to be especially qualified for such use. Statement 245B

In order to comply with FCC radio frequency (RF) exposure limits, antennas should be located at a minimum of 7.9 inches (20 cm) or more from the body of all persons.

Statement 332

The fasteners you use to mount an access point on a ceiling must be capable of maintaining a minimum pullout force of 20 lbs (9 kg) and must use all 4 holes on the mounting bracket.

This product and all interconnected equipment must be installed indoors within the same building, including the associated LAN connections as defined by Environment A of the IEEE 802.af Standard.

The access point is suitable for use in environmental air space in accordance with section 300.22.C of the National Electrical Code and sections 2-128, 12-010(3), and 12-100 of the Canadian Electrical Code, Part 1, C22.1. You should not install the power supply or power injector in air handling spaces.

Use only with listed ITE equipment.

3

Page 2 Page 4
Image 3
Page 2 Page 4
Contents Cisco Aironet 700 Series Access Points Introduction to the Access Point Safety InstructionsAbout this Guide 20A. Statement Configurations Access Point Ports and ConnectorsUnpacking Access Point LED Indicator top Access Point Ports and Connections bottom Configuring the Access PointController Discovery Process Pre-Installation Configuration Setup Preparing the Access PointInstallation Summary Performing a Pre-Installation ConfigurationController Layer 3 devices Cisco Aironet access points Deploying the Access Point on the Wireless Network Mounting the Access PointTroubleshooting Using Dhcp OptionChecking the Access Point LED Troubleshooting the Access Point Join Process Models Declarations of Conformity and Regulatory InformationUSA Vcci Statement for JapanStatement 371-Power Cable and AC Adapter Japanese TranslationEnglish Translation French Translation Industry Canada Canadian Compliance StatementModels Declaration of Conformity for RF Exposure This Device Meets FCC Guidelines for Exposure to Radio Waves Generic Discussion on RF ExposureAdditional Information on RF Exposure Chinese Translation English Translation Chinese Translation English Translation Declaration of Conformity Statements Configuring Dhcp Option 43 and Dhcp OptionOperation of Cisco Aironet Access Points in Brazil Access Point ModelsAdd the option 60 line using the following syntax Access Point SpecificationsObtaining Documentation and Submitting a Service Request
Top Page Image Contents